Windows 10: BSoD Everytime i reset my pc

Ive has this laptop for less than a year and i havent had this issue yet. I just updated it to the latest version of windows 11. Ive had to restart my computer a couple times and everytime I restart it gets stuck on the restarting screen for about 5-10 minutes and then goes BSoD with the error message DRIVER_POWER_STATE_FAILIURE. I have run diagnostics on a few drivers, so far nothing.

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

PC reboots (no BSOD) on CPU stress

Hi fellow TPU members,

not too long ago, the box my gf's PC was transported in gave way on the stairs. Yes, you got it right, that sent a PC tumbling down a flight of steps alright.

Stuff broke. Also, stuff remained intact somehow.

I bought her a new case, new CPU cooler and we removed the floppy drive, so far so good. But the PC started crashing for no apparent reason, without a BSOD.

I tested:

• Memtest86+, left overnight, 0 errors
• Scanned the HDD for errors, nothing there
• Left FurMark burning up the GFX card and drawing some power, no problems there
• Ran Ubuntu from a Live CD doing nothing special, didn't crash
• Ran OCCT, Linpack, Prime95, all 3 caused reboots within minutes
• Oh, and I disabled "Restart on error" so I'm sure it's not a BSOD.

Now, I can still try and test something CPU intensive on Ubuntu, but my guess is the CPU didn't survive.
Before I do anything drastic like whippin' out the magic wallet and get her a new AMD quad, is there anything I didn't see?
I'm guessing the motherboard could be borkered as well, but can I check that other than replacing the CPU with a working one?
Any suggestions on which proggies I can use from an Ubuntu Live CD to stress the CPU?

 

BSOD- atikmpag.sys

This is most likely due to an installation/upgrade error with ATI driver's. I suggest doing DriveSweeper and the following:

• Drivesweeper all drivers & in Safe Mode
• Unistall all drivers that aren't used in DriveSweeper (CCC Profiler Updates, MSI AfterBurner, anything related to ATI that use's it's drivers.)
• After you do this, the first thing you need to do is go into Device Manager and Unistall your ATI Drivers

Once your done, restart the PC and then try installing the latest drivers.


I had several issues with this in the past, but I overcame it with logical reasoning and whenever I have a driver issue, I just use these steps and I always overcome the problem.

Best of luck! *Toast :toast: