Windows 10: BSOD fvefol.sys

My laptop boot up to BSOD. How do I download the DM collector as I cannot access internet. I am using my desktop to post this.

:)

 

Driver Verifier BSOD diagnosis opinions?

Thank you very much for looking at this.

I followed the directions for uninstalling the drivers, and attempted to install new ones that I

downloaded from my motherboard maker, ASUS. Unfortunately, they don't provide audio drivers for anything past Win 7 64 bit, but even though I'm running Win 10, I tried them. The computer would still crash when I ran driver verifier at startup and I had
to use a restore point.

When I checked which drivers were installed, however, it seemed to still be reverting to the original ones that initially caused the problem. So, I did some research on my own and used the Windows Show or Hide Updates program to make sure VIA wasn't auto-updating,
but the issues persisted. So, as a last resort, I simply went to device manager and updated the audio drivers to Win 10 provided by Microsoft, but I'm still getting the driver verifier crash before the system starts. My computer is presently in this state.
As long as I don't use driver verifier, it doesn't crash at startup, but I bet it will after normal sustained use.

The new dump files are here from the trials above. I'm curious if they're all still pointing to the audio driver, and if so/not,
what other steps you might recommend?

 

Driver Verifier BSOD diagnosis opinions?

I used the link provided and selected the option that says the BSOD occurred while using my PC. The link suggests checking for updates and disconnecting hardware. My software is already up to date, and rather than disconnecting random hardware, I was under
the impression from that by uploading the dump files from the Driver Verifier program that from

this post, there might be some clues as to what specific driver is causing the crashes. Is that possible to determine?

 

Welcome aboard.

If the computer does not boot, it would not be feasible to use DM Log Collector in that stage. Please let us see a camera snap of the BSOD screen. Try to make the snap readable .... perhaps the onscreen codes will give us some information.

Also try to Boot to the Safe Mode. Does it boot in Safe Mode or the same BSOD? Let us know.

 

Thank you for the quick reply. attached is the camera snaps. I cannot boot to anything as in the 2nd picture. I have to use recovery usb drive to go to repair screen. I tried to go to previous restore point not success. reset the computer without removing data is also not successful. I can go to command prompt though.

 

Please go through this guide: Troubleshooting stop 0x7B and stop 0xED
Possible explanations to this issue is given there, and there are steps to follow in this situation. Follow the steps 1,2,3 and 7. Also supply a screenshot as per step 6.

All of those will take a time to be completed. Please post the results. I will be off to bed in a while as it is 1 AM already in my timezone. I will check it in the morning.

 

thanks so much. sorry to keep you awake

 

follow step 1,2,3. attached is image from chkdsk. I cannot run step 7. I cannot change the drive to either IDE or Sata. It is on AHCI.

 

OEM manufacturers sometimes does not allow the users to change their BIOS settings and lock it up. I think that is why IDE mode is not accessible there.

Now, please provide a camera snap of the Partition Wizard screen.

 

attached picture after partition recovery.

 

You did a partition recovery? Did you lost any?

Well, if it is still non-bootable, please let us see a camera snap of this window:
Attachment 80589

 

sorry for the delay. I have to make the bootable usb for partition wizard

 

No problem, mate.

Now please Rebuild MBR on Disk 1.
[youtube]QRhJgr0CstY[/youtube]

See how it goes. Let us know.

 

thanks so much. I will try later. also it is very late for you. I will post reply after.

 

rebuilt the mbr with partition wizard. boot to the same bsod.