Windows 10: BSOD Kernel Security Check Failure (ntoskrnl.exe)

while installing the drivers it was saying that the ones I had were in fact out of date...?

so I went through with installation and unchecked the catalyst control panel icon so hopefully no more problems....

I will report back if it BSOD's in the near future and after 30 days i will mark as solved if no more problems arise

 

I didn't say they were out of date, but they might need updating.
If updating doesn't work either, then try an older version and see if it helps.

 

i know you didn't say that, but the installer did

 

Sorry, misread it.
But, it might be correct. Your drivers were from begin last month, there are most likely at least a few new versions released in the meanwhile.

 

OOOOOKKKKKKK Had another BSOD now this time it was a Driver irql not less or equal.


note: again this happened while watching youtube also heres the .zip with dump files and stuff....

Attachment 36393

 

Diagnostic Test

RAM TEST


Run MemTest86+ - Test RAM - Windows 10 Forums



Note



MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.

If MemTest results are positive (zero errors) then try





Diagnostic Test

DRIVER VERIFIER


Warning Please make a backup of your important files and get your rescue media or create one.
Please create a restore point.
Please follow this tutorial run driver verifier.

Some windows drivers are blamed in a few crashes, but that usually means that a 3rd party driver is actually the cause.
Driver verifier stresses your drivers and will crash your pc if any driver fails due to a violation.

Driver verifier should be performed for a max of 48 hours, or when you have a bluescreen, whatever comes first.

If driver verifier has found a violation and you can't get back into windows normally, try to boot into safe mode and reset in safe mode driver verifier, or in the troubleshooting options open command prompt and type verifier /reset.



Note Your system will act very sluggishly while driver verifier is enabled, this is normal as your drivers will be being subjected to heavy testing in order to make them crash.

 

Run MemTest86+ - Test RAM - Windows 10 Forums



Note



MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.

If MemTest results are positive (zero errors) then try





Diagnostic Test

DRIVER VERIFIER


Warning Please make a backup of your important files and get your rescue media or create one.
Please create a restore point.
Please follow this tutorial run driver verifier.

Some windows drivers are blamed in a few crashes, but that usually means that a 3rd party driver is actually the cause.
Driver verifier stresses your drivers and will crash your pc if any driver fails due to a violation.

Driver verifier should be performed for a max of 48 hours, or when you have a bluescreen, whatever comes first.

If driver verifier has found a violation and you can't get back into windows normally, try to boot into safe mode and reset in safe mode driver verifier, or in the troubleshooting options open command prompt and type verifier /reset.



Note Your system will act very sluggishly while driver verifier is enabled, this is normal as your drivers will be being subjected to heavy testing in order to make them crash. ok I will run memtest86 in a few minutes then i will run driver verifier after I get that done.

 

Run MemTest86+ - Test RAM - Windows 10 Forums



Note



MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.

If MemTest results are positive (zero errors) then try





Diagnostic Test

DRIVER VERIFIER


Warning Please make a backup of your important files and get your rescue media or create one.
Please create a restore point.
Please follow this tutorial run driver verifier.

Some windows drivers are blamed in a few crashes, but that usually means that a 3rd party driver is actually the cause.
Driver verifier stresses your drivers and will crash your pc if any driver fails due to a violation.

Driver verifier should be performed for a max of 48 hours, or when you have a bluescreen, whatever comes first.

If driver verifier has found a violation and you can't get back into windows normally, try to boot into safe mode and reset in safe mode driver verifier, or in the troubleshooting options open command prompt and type verifier /reset.



Note Your system will act very sluggishly while driver verifier is enabled, this is normal as your drivers will be being subjected to heavy testing in order to make them crash. Ran Memtest for about 8 passes and 0 errors were found, will start driver stress test tomorrow when i have time to use the computer

 

Run MemTest86+ - Test RAM - Windows 10 Forums



Note



MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.

If MemTest results are positive (zero errors) then try





Diagnostic Test

DRIVER VERIFIER


Warning Please make a backup of your important files and get your rescue media or create one.
Please create a restore point.
Please follow this tutorial run driver verifier.

Some windows drivers are blamed in a few crashes, but that usually means that a 3rd party driver is actually the cause.
Driver verifier stresses your drivers and will crash your pc if any driver fails due to a violation.

Driver verifier should be performed for a max of 48 hours, or when you have a bluescreen, whatever comes first.

If driver verifier has found a violation and you can't get back into windows normally, try to boot into safe mode and reset in safe mode driver verifier, or in the troubleshooting options open command prompt and type verifier /reset.



Note Your system will act very sluggishly while driver verifier is enabled, this is normal as your drivers will be being subjected to heavy testing in order to make them crash.
So I have been running driver verifyer all day today and it hasnt crashed so far which is confusing. i so far have had about 10 tabs of pages open in chrome (my ususal browser) and have played around in steam and origin and have played around with alot of random crap in windows with no crashes.

 

Finally got the computer to BSOD and heres the .zip from the utility
Attachment 36681

 

Its not a bluescreen caused by driver verifier.
Cause is AMD driver.

 

Well Fu** Should I try the beta AMD drivers

 

Wait some time until there is another crash.

Remember, driver verifier should be performed for max 48 hours

 

OK I had it going fine for about 3 days straight with no bsod's and today I attempted to watch a DVD... I installed VLC (my preferred DVD player app) and popped in the dvd and after about 10 minutes it BSOD'd and a few minutes ago I was making a quote for a customer of mine and POOF another BSOD. so heres the output of the utility
EDIT: also let me try some older drivers
Attachment 37409

 

Please check AMD site for driver updates.
Code: 0: kd> lmvm atikmdagstart end module name fffff801`40c10000 fffff801`4211a000 atikmdag T (no symbols) Loaded symbol image file: atikmdag.sys Image path: \SystemRoot\system32\DRIVERS\atikmdag.sys Image name: atikmdag.sys Timestamp: Tue Aug 04 05:28:52 2015 (55C03174) CheckSum: 014ADEC6 ImageSize: 0150A000 Translations: 0000.04b0 0000.04e4 0409.04b0 0409.04e4[/quote]