Windows 10: BSOD Problems with Win10

Hello,


I've Updated on Windows 10 a few Weeks ago (had Windows 8 before). Since i updated, i get multiple BSOD's when Starting up, i usually have to start my PC 4-5 Times before i can even Log in. When i can Log in however, Windows randomly gets BSOD's again wiuthout any obvious reson. sometimes right after Logging in somteimes after 2 Hours of using my PC.

With windows 8 i had no Problems at all.

Also sometimes after Starting up after a BSOD, the sound is not working.


I've run sfc, memtest made sure that all Drivers are up to date etc.


The fun part is that Windows does not create a minidump file as it usually would, thus i cannot give you a minidump file.


Specs:


Intel Core i7-5820K

16GB DDR4 RAM

64-bit Windows 10 Home V1809, Build 17763.195

Nvidia GeForce GTX 1070


Here are some of the most frequent BOSD Errors:

System service exception

Registry filter driver exception

Memory management

KMODE exception not handled


They usually come up randomly and mostly dont show any problematic driver.


I'd appreciate some help on this one.

:)

 

BSOD- atikmpag.sys

This is most likely due to an installation/upgrade error with ATI driver's. I suggest doing DriveSweeper and the following:

• Drivesweeper all drivers & in Safe Mode
• Unistall all drivers that aren't used in DriveSweeper (CCC Profiler Updates, MSI AfterBurner, anything related to ATI that use's it's drivers.)
• After you do this, the first thing you need to do is go into Device Manager and Unistall your ATI Drivers

Once your done, restart the PC and then try installing the latest drivers.


I had several issues with this in the past, but I overcame it with logical reasoning and whenever I have a driver issue, I just use these steps and I always overcome the problem.

Best of luck! *Toast :toast:

 

Windows 10 1709 System Restore problems...


That seems to be an attempt at Option 2 in the tutorial, which requires you to
a. Boot to a command prompt (Did you?)
b. You then seem to be mixing steps 3,4 and 5, thus your command is incorrect.

I suggest Option 1 is easier.

If you still have problems, please repost listing each specific step and saying which option from the tutorial you are using. Thanks.

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.