Windows 10: BSOD with error message IRQL_NOT_LESS_OR_EQUAL a

IRQL_NOT_LESS_OR_EQUAL aAn attempt was made to access a pageable or completely invalid address at aninterrupt request level IRQL that is too high. This is usuallycaused by drivers using improper addresses.If a kernel debugger is available get the stack backtrace.Arguments:Arg1: ffffdb8142b8985c, memory referencedArg2: 00000000000000ff, IRQLArg3: 00000000000000f3, bitfield : bit 0 : value 0 = read operation, 1 = write operation bit 3 : value 0 = not an execute operation, 1 = execute operation only on chips which support this level of statusArg4: fffff806c861eef9,

:)

 

Irql_not_less_or_equal

So I have this clients PC that blue screens and gives a IRQL_NOT_LESS_OR_EQUAL STOP 0x0000000A error message. Error Goblin (link in sig) says the following:

And I have NO IDEA what the hell that means. It has wrapped around my head 5 times and caused it to explode. Ive ran memtest for 7 and a half hours and it didnt find any errors. I will probably run it again overnight just to be safe. Ive also cleaned out the computer with an air compressor and checked the hard drive for bad sectors are none are to be found.

Im trying like hell to avoid reinstalling Windows but it seems unlikely.

Im going to try updating some drivers and see what happens. Some of the drivers on this computer date back to 2007.

Suggestions are greatly appreciated.

Thanks guys.

EDIT:

Alright so it doesnt look like ill be able to get onto the internet to do anything because nearly every time i try, i get the BSOD. Format seems imminent.

 

BSOD problems IRQL_NOT_LESS_OR_EQUAL + MEMORY_MANAGEMENT + PAGE_FAULT_IN_NONPAGED_AREA

Some days when I turn off my PC it happens sequentially these 3 BSOD (IRQL_NOT_LESS_OR_EQUAL + MEMORY_MANAGEMENT + PAGE_FAULT_IN_NONPAGED_AREA). Not necessarily in this order. But the errors are basically one of these.

• I've already done memtest86 and got no errors
  
• SFC /scannow with no errors too
  
• checkdisk with no errors
  

I've checked the error with BlueScreenView and the problem is with the driver ntoskrnl.exe.

Any suggestion of whats going on?

 

BSOD error messages, assumed to be from overclocking.

Alright, I got this error message today and it was the only one I had time to be able to see and write down. This is what it said.


IRQL_NOT_LESS_OR_EQUAL

STOP: 0x00000004, (0x6D58337f, 0X00000002, 0X00000000, 0X806E772F)


any clues to what this is. Too much voltage to proc? Unstable FSB setting with a 3x LDT (HTT) and 8.5 on my Opty 165 mutli?

thanks guys