Windows 10: BSOD

Hi I really would like an opinion on my BSOD faults each time I boot up I have an automatic re-start on a daily basis with a different reason ie

Not less or equal System Service Exception Memory Management Mode Exception Not Handled Invalid Push Fault In Non Paged Area Frustrating to say the least my OS is windows 10 any suggestions very welcome

:)

 

Random BSOD while browsing internet


BitDefender is nothing special. mwac.sys causes BSODs anywhere.
A tiny documentation can be found here: Solved Random BSODs - Windows 10 Forums
In that very thread, the suggested action apparently worked.

The storage and network filters of any third party antivirus can cause BSODs. Neither MBAM nor BitDefender is any special. For a regular antivirus, it may be shifted to an alternative; but MBAM has no alternative. So a clean install of the said program is the most feasible first step.
As far as the first step is not failing, it is better to not think for the second step. Because the BSODs are not universal, failure at the first step is not universal; and success at the second step is also not universal.
That is why I posted that my suggestion may work, or may not. Let us see where it goes.

 

7 different BSoD

Hey guys,

I have a serious problem. I make it as short as possible:

• system runs 100 % fine with the 10.12
• updatet to Catalyst 11.1 -> BSoD
• updatet to 11.1 Hotfix -> BSoD
• rollback to 10.12 -> BSoD
• removed ALL AMD files manually, installed 10.12 -> BSoD

• Temps are fine
• no sfc /scannow errors
• no chkdsk errors
• Prime, Furmark all fine
• regardless what driver I install -> BSoD
• I did no hw changes, no OC

Here are my BSoDs I receive:

• 0x0000010e
• 0x1000007e
• 0x0000007e
• 0x0000004e
• 0x0000003b
• dxgmms1.sys
• PFN_LIST_CORRUPT

They all refer to the GPU of course ...

From now on I receive a BSoD every time I try to play a game (especially BC2 and SC II) even if I completely remove the old driver and make a clean install.
Apparently the 11.1 damaged my system irreparable.

Any advice or info would be very much appreciated *Smile

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.