Windows 10: Can't calibrate flight yoke?

Hey there! I've been trying to calibrate my Flight Yoke System for MFS 2020, and it doesn't seem to work. I've followed all the guides telling me to find it in the control panel, shift ctrl left click on properties etc, it doesn't work.



Game controller properties, even when shift ctrl clicking

Is there another way to calibrate the controller? I'm mostly looking to get rid of the natural offset of the yoke. For some reason, the X axis is always pushed slightly right. Is there some program that can fake an input to cancel it out?



X axis constantly pushed to the right, even when there is no input.

Thanks in advance!

submitted by /u/OrionIdalia
[link] [comments]

:)

 

Saitek pro Flight Yoke + Windows 10


Hi bachian,

I have encountered exactly same incident as yours, and I noticed it might be caused by recent Windows 10 update (TH2) whichinitialized some device drivers, such as Saitek Pro Flight Yoke of ours.

So, what I did are as follows;
1. Run "Installer CD" which wasinitially bundled with Flight Yoke.
2. The above installer will also stuck atthe timing to plug the yoke into the USB port as you/we experienced, and thenpress "cancel" to quit the installer.
3. After above operation, the followingfolder has been created, in which driver files are extracted.
c:/windows/temp/Saitek/Saitek_Pro_Flight_Yoke_SD6_64_Drivers
4. Open "device manager", andselect Flight Yoke which would be shown as "unknown device", andselect "renew driver" designating above folder, then PC can recognizeFlight Yoke, now.
5. Then, run "installer for Windows10" downloaded from Saitek official web site, and which will run properlyand terminate successfully.

Hope this will be some help for yoursolution.
Thanks,

 

Pro Flight Yoke System stops working

Hello,

I'm having an issue when using my Pro-Flight Yoke System with FSX in Win7 64Bit.

The system stops working while I'm flying and I have to plug in back again.

I have installed the latest drivers from Saitek/Logitech to make it work. I'm using an Hub USB and the Yoke is supplied by a separate 5V powered unit.

I was not having this problem before.

The driver is working correctly !

Do you know how can I fix this issue?

Many Thanks !

 

Saitek pro Flight Yoke + Windows 10


Hi,

I just mounted a brand new computer. A nice rig, with the best a could find on the market. My intention is to primarily use this computer for flight simulation and training purposes.

I have the Saitek Pro Flight Yoke, witch I have been using on my old computer running Windows XP for 6 years. But when I plugged into my new computer, it never recognizes it after the computer initialization, so I had I physically disconnect and reconnect it to the USB port. So I decided to go to saitek.com and download the latest yoke drivers.

After that, the problem got worse. The yoke are not recognizable anymore. When I tried to reinstall the drivers, It didn't work, since in the middle of the installation, it requires me to plug the yoke in the USB, but as it does not recognizes it, it does not let proceed with the installation.

I have tried several things to isolate the problem. I plugged the yoke in all other USB ports, 2.0 and 3.0 (witch works fine with other peripherals), tested back on my old pc (and it´s working fine there) and clean the registry and try to reinstall the driver again.

I'm almost sure it's something related to Windows, as during the computer initialization, the yoke lights turn on until Windows are up.

I don't know what else to do. Anyone has some insight?