Windows 10: can't open sign-in options

Once i click sign-in options, the settings window freeze.

:)

 

Sign in Options wont Open

Build version: 14393.693

I would like to add pin as a sign in method,

but this problem did'n encounter very often

It usually be normal after I restart the windows





I have been following this instruction, but seems like nothing is solved

Method 1:

This issue may happen due to system file corruption. I suggest you to run System file checker. System File checker (SFC) scan is done to check if there are any corrupted system files that could be causing this issue. Kindly follow the below given steps:

• 
  Press Windows key + X, select Command prompt (Admin) to bring up elevated Command prompt.
  
• 
  In Command prompt type sfc/scannow and press enter.
  

• Restart the computer.

Method 2:

If no corrupted system files were found in the previous state, then I suggest you to try the following steps to employ the DISM command lines:

• 
  Open command prompt by pressing Windows key + X and selecting “Command prompt admin”.
  
• 
  In command prompt, type the following commands and press Enter after each command:
  

DISM.exe /Online /Cleanup-image /Scanhealth

DISM.exe /Online /Cleanup-image /Cleanupimage

DISM.exe /Online /Cleanup-image /Restorehealth

• 
  Close the command prompt and restart the PC and check if it works.
  

Redirecting

I also encounter these problem :

 

my sign in options doesn"t open in settings.

Hii, my sign in options doesn"t open in settings. everything else works fine in settings. i just want to change sign in from password to passcode . It was working very good before. After new update in last month, it stopped working and after update it
asked me to relogin but did not gave me the option to set 4 digit passcode .

 

How does Windows boot to advanced recovery option e.g. command prompt?

- that gives me a 454 'Unexpected error' This tells me that the BCD is partially corrupted.

The commands: shutdown.exe /r /o /f /t 00
or: %SystemRoot%\System32\Cmd.exe /c reagentc /boottore&shutdown /r /f /t 00
should boot into Recovery if everything is configured correctly.
FYI, If Windows is configured correctly:

1. If Reagentc is disabled, you still can get into Recovery but with limited options.
2. If Reagentc is enabled, you'll get all options.
3. If you boot Windows using Recovery USB stick, You'll get into Recovery with couple of options missing.

Here's my suggestion if you want to try:
OPTION 1: Will save the trouble of re-install Windows.

1. Download the image of my first 3 partitions (450MB Recovery, 100 MB EFI partition, and 16MB unformatted primary)
   EFI_Boot-00-00.7z - Google Drive
2. Run Macrium and restore the image from step 1, overwriting your existing 1st three partitions, leaving C alone.
3. Delete the 490MB Recovery partition.
4. From Macrium, run fix boot problems.
5. Reboot. Open Admin command prompt then run Reagentc /info to make sure that it is enabled. If not, enable it.
   if failed to enable, reboot and try again.

OPTION 2: Assuming you've already had Windows backup with Macrium.

1. Wipe out the first 5 parttiions. (450MB, 100MB, 16MB, C Drive, 480MB)
2. Fresh install Windows 10
3. Restore C drive from backup image, run fix boot problems
4. repeat step 5 from OPTION 1 above.