Windows 10: Can't reset my PC by any software method

Hello everyone!
I've got an issue...lemme tell you:


My laptop lenovo 320 was good, but suddenly, I got some errors. It all started with a BSOD...well, some BSOD with errors like

KERNEL DATA INPAGE ERROR. It appeared and the laptop restarted, ok? But when I tried to navigate through the laptop using apps

like Chrome or even just opening a folder, the laptop kinda freezed from 1 to 5 seconds, some time passed and the laptop would restart again.


I though it was bc I had a screen connected through HDMI, disconnected it, but nothing changed. The error still ocurrs. BSOD and freezing like for some times.


I noticed the windows updates were not installed since 14 days ago, so I tried to update 'em, that may solve the problem, right?

Well, I couldn't do it.


There was another error, the error 0x800f0805.


And I tried everything, from the thing of /scannow and those commands using the administrator privileges, to: trying to reset the pc, first keeping my files, and then removing my files. But it appeared always...always: "There was a problem resetting your pc".


Then I decided to try it in safe mode. Surprise, it did nothing, the same message.


Now I tried to leave safe mode, but when I open msconfig, it leaves: The code execution cannot proceed because bcd.dll was not found. Reinstalling the program may fix this problem.

A system error...


I cannot even leave safe mode.


And now I just want to reset this pc, and start all over again.


The question is: May somebody help me to reset the laptop? Any other methods? Or is it done?



Thanks in advance, ladies and gentlemen.

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Overclocking / Undervolting guide for Vega 56 or 64?

Here's a quick laundry list:

List of software to use for overclocking and testing
Examples:
Wattman (and how to find and use it, like an overview, including profiles)
Unigine Valley or Heaven (use this for quick testing while changing settings in Wattman and checking for stability / artifacts) ...just suggesting this
How to monitor cores / mem speeds and temps during testing (I've seen screen overlays, and others using GPUz)

Step-by step overclocking in Wattman
Fan speeds
Power limit
Temp limit
Voltages
Core speeds
Memory speeds

 

resetting the pc

Hi,

There is a possibility that this is due to software corruption. To properly isolate the issue, kindly verify the following:

• Have you performed Reset this PC option?
• Did you encounter any error messages?
• Any recent changes made on the computer prior to the issue?
• What troubleshooting steps have you done to fix the issue?
  

We're looking forward to your response.