Windows 10: Can't reset my PC

Hello everyone,

My notebook with Windows 10 is showing a blue screen with the error 0xc000021a every time I try to access the Windows.

When I turn on my notebook, it shows the message: 'Automatic Repair couldn't repair your PC' and the options: 'Shut down' and 'Advanced options'. I already tried to fix the computer on the 'Advanced options', using several methods that I found on sites and videos, but nothing I tried worked.

For example, if I choose 'Repair your computer' and then 'Startup Repair' on the 'Advanced options', it returns a SrtTrail.txt error. I also tried to run a LOT of commands that I found on the internet in the Command Prompt to try to fix this error, but none worked. I also can't restore the system, because it says there's no system restore points available, and I can't boot into safe mode either.

So, I tried to reset the notebook on Advanced options > Troubleshoot > Reset this PC > Keep my files. Then I confirmed on 'Reset' and the notebook started to reset, but when it was about to 50% concluded, unexpectedly my PC stopped the reset and went back to automatic repair. I tried this procedure three times, and the same thing happened in all.

Does anyone can help me, please? What's happening, why can't I reset my notebook? What I need to do to be able to reset my PC or fix the blue screen so I can get back to use my notebook normally?

Thank you

P.S.: sorry for any mistakes in my text, English isn't my first language.

submitted by /u/thiago_roska
[link] [comments]

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

I can't factory reset my PC

Hello Caitlyn,

We still can't confirm the possible causes of the issue you're experiencing when resetting your computer. For us to gather more information and assist you better with this, kindly answer the following questions:

• Can you tell us the exact error message you get when you attempt to reset your computer?
• Can you also tell us how you reset your computer?
• Any troubleshooting steps you've tried so far?

We look forward to your reply.

 

PC Build Steps

Ok just because I like steps i am going to create some steps. Please give me the stamp of approval/disapproval

• Install system in case
  • Remember to connect SSD and optical to same SATA ports on motherboard
• Turn on PC
• setup HDD
• run blend test in prime95 for 30-60 min
  • run realtemp at the same time

• While in Prime95 test
  • if CPU goes above 70c in RealTemp, I have a leaky CPU
  • if my system locks up or blue screens, there is an instability in the system somewhere
  • if my system does not lock up or blue screen, my CPU is not damaged and I am in the clear!

What do you guys think??