Windows 10: Changing display driver to windows basic display adapter using command prompt

ok. So I installed uhd graphics 620 and now my window won't start and is stuck in bootloop. I want to set display driver on windows basic display adapter using command prompt in setup recovery.. How do I do so please help.. last time I fix this problem using safe mode but this time even safe mode not working

:)

 

No Display after Microsoft Basic Display Adapter

Hi,

As you are facing issues with changing the brightness on your device, do not worry we will help you with this issue.

Provide us additional information to assist you better:

• What is the make and model of your computer?
• What exactly happens when you try to change the brightness on your device?

Make sure that you are able to access the display on your device to follow the below troubleshooting step.

I suggest you to download the latest drivers from the manufacturer's website, place the computer in Safe mode with Networking, uninstall the existing drivers, re-install the new drivers manually and check if it helps.

Step 1: Boot the device to Safe mode and uninstall the existing drivers and restart the computer.

Refer: Start your PC in safe mode in Windows 10


Step 2: Steps to Uninstall the Display Adapter driver.

• Press Windows key + X key when you are at desktop.
• Select Device Manager.
• Expand Display Adapter.
• Right click on the Display Adapter and click on
  Uninstall.

Refer to the article by Ander Da Costa on
How to: Install and Update drivers in Windows
10, try to install the drivers in compatibility mode.

Step 3: Follow the below steps to
place the computer in normal mode.

• Press Windows + R keys to open
  Run command.
• Type msconfig and press
  Enter.
• In the System Configuration window, click on
  General tab.
• Select Start-up selection as
  Normal startup, click on Apply
  and Ok.
• Follow onscreen instructions.

Hope it helps. Reply to the post with an updated status of changing the brightness for further assistance.

Thank you.

 

The graphics driver shows as “Microsoft Basic Display Adapter” after upgrading to Windows 10

Hi,

With regard to your query, your Display Adapter is listed as Microsoft Basic Display Adapter instead of the correct driver name. If you have recently update your display card driver, and this problem comes along, what we can try to do here is to roll the
display adapter's driver back to it's previous version.

Please follow the steps below:

• Press Windows key + X and select Device Manager.
• Expand Display Adapter's category, and right-click Microsoft Basic Display Adapter, select
  Properties.
• Under Driver tab, choose Roll Back
  Driver.

If rolling back the driver is unavailable, update the display driver manually.

• In Device Manager, expand Display
  adapter's category and right-click Microsoft Basic
  Display Adapter, and select Properties.
• Under Driver tab, choose Update Driver.
• Select Browser my computer for driver software.
• Click the Browse button, then navigate to the folder where you place the downloaded display card driver setup file.
• Reboot the computer for the changes to take effect.

Let us know the result.

 

microsoft basic display adapter

VGN-FS570, clean install from xp to win 10 having a problem the graphic display, only seeing microsoft basic display adapter, not getting the full screen of the display, cannot change the adapter, tried
to install adapter, not supported by your device

the problem is cannot change microsoft basic display adapter, not getting full screen on display, also seeing a yellow arrow on the adapter in device manager, was able to get full screen when using win xp. how do i fix this problem,
I have tried numerous technique without success

•