Windows 10: Changing PORT.? inside a FUNCTION

Hi,
I'm using Oshonsoft Basic, I'm not sure if this matters!

I'm learning FUNCTIONS/PROCEDURES, and inside one there is a CHIP/SELECT. There are three peripherals that use the same FUNCTION, and need selecting in turn before calling it. Which is the best way of switching between the three C/S before calling the FUNCTION, please?
Cheers, Camerart.

 

Hard drive turned RAW after changing sata port. Table resotration

Here is the result. I appreciate you going through step by step with me.





When selecting List, the filesystem still seems damaged.

 

USB 2.0 Ports Stopped working

Hello,

I recently noticed my USB 2.0 ports have stopped working, but my USB 3.0 port is functioning perfectly.

Steps i have tried:

- Restarting

- Searching for device changes in Device manager

- running troubleshooter

all these suggested fixes didn't remedy the issue, its a bit of an inconvenience that i only have one functioning USB port

Thanks

 

Changing the Port settings for Serial-USB.

Hi,



Thank you for writing to Microsoft Community Forums.

If you want to change the port settings, please follow the steps mentioned below:

1. Open Device manager (right click on start button
   and then on Device manager).
   
2. Then expand port (COMS & LPT).
   
3. Then right click on Prolific USB-to Serial Comm Port and then on properties.
   
4. Go to port settings and click on Advanced.
   
5. You will be able to make the changes on this screen.
   

Hope this helps.