Windows 10: Click on Power/Sleep but it goes to Lock screen instead

Win 10 ver 2004. It seems like it is trying to go to sleep because it goes to a black screen for about 10 seconds, then goes to the lock screen. (If on the other hand I click the Username/Lock it goes immediately to the lock screen, so I think it is trying to sleep and unable to.) I've tried disabling Hybrid Sleep, updated drivers, Ran powercfg -requests (showed None). Any ideas? Thanks

:)

 

Windows 10 goes to lock screen instead of sleep mode.

My computer has this problem for a while but i haven't found any solution online.

My PC doesn't go to sleep mode by being idle anymore, instead of going to sleep mode it just locks the user and goes to the lock screen.

The only way to go to sleep mode is to put my PC manually.

Did anyone experienced that issue?

Any suggested solutions?

Thanks!

 

PC hibernates / goes into sleep mode upon logout / screen lock

I am using my work computer. It's a laptop with a power connection (not running on battery.) The laptop is hocked up to two monitors (a total of three monitors, counting the laptop's own screen - I usually keep my laptop closed, however.)
Since I am at work I always lock the screen when I leave my computer. (I use the windows+L shortcut to lock the screen.) This all works fine.

However, after about a minute the computer goes into sleep mode / hibernation. At least I think it does, because the two monitors goes black - and it takes a few seconds to "wake up the system" (the monitors doesn't come back to life immediately when I press a key on the keyboard / move the mouse, as they would if a screen saver was active.)
This is very annoying if I step away from my computer for only a short while (like going to the bathroom.)

Here's what I want:
With power (not running on battery):
When I lock the screen, I want the screen to stay on for 1 minute, then go to screen saver for 15 minutes, then go to hibernation/sleep mode.

Without power (running on battery):
When I lock the screen, I want the screen to stay on for 1 minute, then go to screen saver for 5 minutes, then go to hibernation/sleep mode.

My best bet is that this is some sort of power saving scheme thingie, but I can't seem to figure out how to configure it to do what I want. Can someone please help me with a step-by-step guide to configure my system the way I want? Thank you.

 

BSOD seemingly when computer goes from Power-state S0 to S1-3

Please switch to the Beta log collector listed at the bottom of the Blue Screen of Death (BSOD) Posting Instructions

It collects additional data that may be use here, one of which is some power info. Is you are allowing your computer to go to sleep, I suggest not doing that but instead, either shutting down or using the screen saver (Lock Screen) to blank the screen but not allow sleep. See if that gets rid of the BSODs.