Windows 10: connecting to 3d printer

Im trying to connect to my 3d printer mother board through com 5 but it says it cannot open port 5 and has a baud rate of 115000 i believe. my motherboard has it set at 250000. how can i change so i can connect to it and flash new firmware. if i use pronterface i csn connect to it and send and receive data but not with prusa slicer. is there a way to change baud rate to com port? or what am i doing wrong?

:)

 

3D Builder Program Printers

Hi Sam,

Yes, you can try and see if it will be compatible. However, we have a list of printers that are compatible to Windows 10 and the 3D Builder app. For more information regarding the suggested printers, click this

link.

Do not hesitate to reach out to us if you need further assistance.

 

connecting laptop to Office jet G55 printer

Hi Luisa,

To help you with your concern regarding the printer, let me suggest you to contact the manufacturer for the steps on how to connect your printer to your computer. Please follow the steps on how to contact the manufacturer:

• The name of the OEM + “contact information”
• The name of the OEM + “PC support”

Regards.

 

Windows 10 + printer connection

Hi murlichatlani,

Have you tried the suggestions on my initial post, in response to the original poster? If you haven't performed any troubleshooting yet, here are a couple of things you can try:

• Power off, and then power on your printer to restart it. Wait for a while for it to be fully ready.
• Check your printer connection. Check your printer and make sure that it’s connected to your PC network.

If the steps didn't help, you may go through this list of suggestions to fix printer connection in Windows 10.

If you would like me to provide additional advice, simply respond to this thread. I will get notified and I’ll reply to you as soon as I can.