Windows 10: Critical Process Died - BSOD

Hello,There was a blackout, and upon starting my computer, I was greeted with the blue screen of death, with the only message being "Critical Process Died."I attempted all the recovery options available:Safe mode gives the same error; critical process diedchkdsk /r completed, but did not do anythingSFC /scannow does not start. Windows Resource Protection could not start the repair service.DISM /image disk /cleanup-image /restorehealth does not start. It throws the error, "could not find file specified"This command works when directed towards a disk with a fresh windows installation.System

:)

 

critical process died

Hello,

Please try suggestions mentioned here:

[FIX] CRITICAL_PROCESS_DIED BSOD In Windows 10

Hope this helps, Good luck

 

BSOD Critical Process Died




This is my config, what should i do?

- - - Updated - - -

I tried also this:
Step 1. From the initial Windows screen, accept the default settings for the language to install, the time and currency format as well as the keyboard or input method. Next, click the Repair your computer link instead of Install now.

choose Repair your computer
Step 2. Select Troubleshoot and then Advanced Options.

Step 3. Select Command Prompt.

Step 4. Type diskpart and press Enter key.

Step 5. Type list disk and press Enter. Now pay attention to the disk number and identify which one is the boot disk. Usually, it is Disk 0; if not, find the disk number in your own case and remember to type the correct one in the following relevant steps.

Step 6. Type select disk 0 and press Enter.

Step 7. Type list volume and press Enter. Now pay attention to the volume number of the EFI partition.

Step 8. Type select volume N and press Enter. Also, type the one in your own case instead of N.

Step 9. Type assign letter=N: and press Enter. N: can be replaced by any drive letter that is not taken by any partition. Remember which drive letter you assign here for it is rather useful in the rest steps.

Step 10. Type exit and press Enter to leave diskpart.

Step 11. Now type N: (the drive lettered you just assigned) and hit Enter.

Step 12. Type format N: /FS:FAT32 and hit Enter.

Step 13. Type bcdboot C:\windows /s N: /f UEFI and hit Enter.

Now repeat the process of running the bootrec /fixboot command, bootrec access is denied Windows 10 should be solved now. But if fixboot access is denied occurs on an MBR disk, continue with Fix #2.

All steps until 13. was executed successfully, but still became on
bcdboot /fixboot
Error: Access is denied. And I have a GPT and no MBR Partition

bootrec /rebuildbcd
was successfully, founded Win installation: 0 (ZERO)
complete

bootrec /scanos found also ZERO installations

 

BSOD critical process died

My replies in red.