Windows 10: Device not recognised

I am trying to sync music to my Ipod - The device is not able to be added even though it is showing as being connected.. The odd thing is my Ipod is showing as being F drive and the music is appearing on the drive but when I eject my Ipod the music is nowhere to be seen. Thank you

:)

 

USB wireless mouse 'USB device not recognised'

Hi,

There are a lot of possible reason why this issue has occurred. We have some
questions for your to isolate this matter:

• 
  Have you tried using the USB mouse to other computer?
  
• 
  Is this happening with other devices?
  
• 
  What other troubleshooting steps have you done so far?
  

We suggest that you perform these methods of troubleshooting steps and check if there's any changes:

Method 1: Run the
Hardware and Devices Troubleshooter.

To run the
Troubleshooter,
follow these steps:

• 
  On the search bar, type
  Troubleshooting
  and hit
  Enter.
  
• 
  Choose
  Hardware and Sound.
  
• 
  Click on
  Hardware and Devices
  to run the troubleshooter
  

Method 2: Update your drivers.

To know how to update your drivers, click
here.

Method 3:
Run SFC Scan.  

To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Method 4:
Run DISM Tool.  

To run
DISM Tool, follow these steps:

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type the following command:  
  
  • 
    DISM.exe /Online /Cleanup-image /scanhealth  
    
  • 
    DISM.exe /Online /Cleanup-image /Restorehealth  
    

NOTE:
This might take a while to finish scanning.
Do not cancel. 

Method 5: Clean Boot.

To perform a
Clean Boot, click
here.

Note:
Reset the computer back to
Normal Mode
once you are done with the troubleshooting by following the section
"How to reset the computer to start normally after clean boot troubleshooting"
from the same article.

If the issue persists, it is possible that the
device itself has issues. We suggest that you
contact the store
from where you
bought the device.

Let us know how it goes.

Regards

 

USB Devices not recognised.

I have two devices that regularly are not properly recognized by Windows 10 one is a Garmin GPS and the other is a DJI Phantom Drone. In the case of the Garmin the USB Drives are recognised by Windows (Confirmed using USBDEVIEW) but the software does
not recognise the device and continues to search for it.

In the DJI case it seems to recognise the device but the software cannot access the Drone information i.e. Version Numbers etc. It also often reports errors on the SD Card inserted into the Drone but no errors are reported if the SD Card is inserted into
a card reader.

Any suggestions that I can try would be appreciated.

 

New SATA drives recognised by BIOS but not detected by Vista

Right, I managed to get them to show up! Yay! However, there is still a major problem. Vista does not recognise them as hard drives.

In Device Manager, they are under "Other Devices" and both are listed as "MAXTOR S TM3250310AS SCSI Disk Device". I can't install any drivers for them and they do not show up in the Disk Management panel still.