Windows 10: DISKPART ERROR

So i was trying to Install Windows On my HDD and While Deleting and Partitions i wasn't able to Able to Delete them , so i tried Using DISKPART in Cmd and Encountered a error , shown in the Photograph what should I do ? I cannot Enter My windows 10 neither reinstall It!

:)

 

diskpart doesn't show disk

Hey,

I am trying to install Win10 on a mac book air.

However the diskpart does not list the disk even after reformatting the partition as NTFS per suggestion.

read through this solution but cannot move to step 1 listed in the solution by Ivan as that disk doesn't see that partition it was just able to reformat.

Regards

 

Diskpart problems?

Hi again, I tried what you suggested and got the same error message as before. I spoke to a guy on another forum and he suggested typing the "Active" command before doing the Format.
diskpart
list disk
select disk # <-replace # with the actual number for the USB flash drive
clean
create partition primary
select partition 1
active
format fs=fat32 quick
He tried it on a Windows 7 PC with the Active command straight after format and he was told to select a partition again...but when selecting Active first before format it was fine.
Im thinking that might be the case on my Windows 10 laptop too but instead of getting a reminder to select a partition I get an error. After the error message If I select a partition and Type Active everything is OK. It seems a bit strange I know!!

Can I ask you though. Is it OK to type the Active command before the Format command or should Active only be typed into Diskpart after the Format has been done?

 

DISKPART CLEAN

Hello

I'm Peter F independent Advisor

You will get this error when you are using diskpart clean command on system disk. The system disk contains the Windows operating system files and other critical files, if you are allowed to clean the system disk, all the data and partitions will be gone. That
will result in a lot of errors and chaos. Meanwhile, the delete volume is greyed out in Disk Management. In this case, the new SSD drive may be regarded as the system disk due to the system files, etc.

Using Windows installation disc to clean

If you have the Windows installation disc, you can follow these steps to solve clean is not allowed issue in Windows 7/8/10:

1. Insert the Windows installation disc, then boot from it.

2. Click Repair your computer> Troubleshoot > Advanced Options > Command Prompt.

3. Then input the diskpart commands to clean hard disk:

diskpart

list disk

select disk [disknumber]

clean

Diskpart Clean

Then you could create a new partition on the drive to solve this problem.

Reference

https://www.disk-partition.com/articles/virtual...

This is a non-Microsoft website. The page appears to be providing accurate, safe information. Watch out for ads on the site that may advertise products frequently classified as a PUP (Potentially Unwanted Products). Thoroughly research any product advertised
on the site before you decide to download and install it.

I hope it helps