Windows 10: dism error 50 the request is not supported

Hello,

I have a lot of problems in my windows 10 laptop so I found that solution is checking for system files so I go to cmd then write


DISM.exe /Online /Cleanup-image /Restorehealth


it worked until 84.8% and then stopped for a while then I pressed enter to see what will happen and it throws error 50 the request is not supported


I did it 3 times and it prints that error


My windows up to date


so what can I do please?

:)

 

Error 50: The Request is not supported


I noticed that Superfetch service is not loading any more even being set in "Auto". I tried manually to load it, but i get the error:

Windows Could not start the superfetch on local computer.

Error 50: The Request is not supported

Windows 10 is up to date and i have no SSD disk, just a hybrid hard drive as stated in an old thread, but it was working before.

 

Cipher Error : The Request is not supported.


Upon trying to use Cipher to do some simple encrypting on my machine I have ran into some issues.



If I execute Cipher.exe from the Command Prompt it seems to be functioning normally and subsequently lists all folders on the current directory with a U in front of them indicating that they are unencrypted, however, when I attempt to encrypt a directory ... or rather the files within it ... I get an error that reads " The request is not supported " beside each file listed in the directory and an overall summery that 0 files were encrypted.

I noticed that there is no Cipher.dll file on my machine, as according to some due diligence research, perhaps should have been. I located the only cipher.dll I could find, however, upon trying to register it I received an error that " the module was downloaded but the entry point DllRegisterServer was not found. I also found an update on Microsoft's website, (KB4032188), that claimed to resolve known Cipher issues, however, was unable to install it on my machine as it kept stating that the update was not applicable to the particular Windows 10 build I am running. I also tried to use TLS 1.0 only and still received the same error. Any ideas?

 

DISM - Parameter "Cleanup-Image" is not known (error 87)

Hello Eric,

To troubleshoot your concern, we suggest that you run DISM Restore Health command. Refer to the steps provided below:

• Open Command Prompt (Administrator).
• Type the following command:

DISM /Online /Cleanup-Image /RestoreHealth

3. Press Enter.

Let us know how it goes.

Thank you.