Windows 10: Eltűnik a WiFi kapcsolat alvó állapot után

Adott egy nem mai Acer Aspire E-5 laptop Qualcomm Atheros QCA9377 WiFi adapterrel.Ha lehajtom a laptopot alvóállapotba kerül, ha felhajtom akkor legtöbb esetben nem csatlakozik a WiFi-re, mert nem látja a WiFi-t, már mint a beépített adaptert, eltűnik az adaptereknél a WiFi. Idegesítő, mert csak az újraindítás oldja meg a problémát, viszont mivel régi a gép eléggé lassan indul.Egy ideje küzdök a problémával, jó pár verzió óta nem működik, eddig arra gondoltam lesz javítás a problémára, de semmi változás, és nagyon idegesít.Várom a válaszokat, ötleteket.

:)

 

Windows 10 wifi icon shows not connected - connections available - but internet works fine?

Hi Nik,

Thank you for reaching out to us. We suggest you to try to disable auto turn-off of WiFi device by following the steps below:

• Go to Network and Sharing Center.
• At the right pane, click Change adapter settings.
• Right click on your connection name (WiFi name) and Properties.
• Click the Configure... button.
• Go to Power Management tab.
• Uncheck/disable the radio button for "Allow this device to turn off this device to save power".
• 
  Restart the PC (Important)
  

We will wait for your response.

Regards.

 

Since the change to W10, PE9 still functions but it cannot connect with Nik and an error message pops up - 'Could not complete Silver Efex command because of a program error'.

Hello,

This might have occurred due to compatibility issue.

As an initial troubleshooting step, I suggest you to uninstall and reinstall both PE9 and Nik and see if this helps in resolving the issue.

If the issue still persists, I suggest you to contact Nik Collection
regarding this matter for assistance.

Nik Collection by DxO – Customer Support

Photoshop Elements 9

Photoshop Elements Help | Photoshop Elements User Guide

Thank You.

 

Windows 10 wifi icon shows not connected - connections available - but internet works fine?

tried the below mentioned ideas

Hi Nik,

Thank you for reaching out to us. We suggest you to try to disable auto turn-off of WiFi device by following the steps below:

• Go to Network and Sharing Center.
• At the right pane, click Change adapter settings.
• Right click on your connection name (WiFi name) and Properties.
• Click the Configure... button.
• Go to Power Management tab.
• Uncheck/disable the radio button for "Allow this device to turn off this device to save power".
• Restart the PC (Important)
  
• 
  
• • Right click on Start and click Command Prompt (Admin) and enter this command:
  
  netsh int ip reset
  
  • Hit Enter key. Now, monitor your WiFi connection. Original link: How to reset TCP/IP by using the NetShell utility.
  You can also try to reconfigure TCP/IP on the details below:
  
  • Right click on Start and click Command Prompt (Admin) and enter the following commands:
  
  netsh int tcp set heuristics disabled
  
  
  
  netsh int tcp set global autotuninglevel=disabled
  
  
  
  netsh int tcp set global rss=enabled
  
•