Windows 10: Enabling Hyper v causes a bsod

When I enable hyper v I get the bsod of death SYSTEM_THREAD_EXCEPTION_NOT_HANDLED. some other details are that I also have bluestacks and vmware installed. I also have dmp files if you want to see them.

Help is very much appreciated

submitted by /u/Endlesserrors1
[link] [comments]

:)

 

Can't Enable Hyper-V in Windows 10 Professional

Hi,



Thank you for writing to Microsoft Community Forums.



I appreciate your effort on this. As per my research the error code 0x800f0831 is generated when .Net Framework 3.5 is not enabled on the computer. I suggest you to try enabling .Net Framework 3.5 on the computer. Follow the steps mentioned below:

1. Press Windows key + R, to open
   Run dialog box.
   
2. Type appwiz.cpl and click on
   OK.
   
3. Click on Turn Windows features on or off.
   
4. Now, select the check box for .Net Framework 3.5 and click on
   OK.
   
5. Restart the computer.
   

You can also check if Virtualization feature is enabled in BIOS or not, if it is not enabled, I suggest you to enable it.



You may also refer the troubleshooting steps performed by Jins Peter replied on August 13, 2019 in the thread

Hyper-V on Windows Pro wont install and see if that helps.



For additional information, you may also refer the article
Step-By-Step: Enabling Hyper-V for use on Windows 10.



Disclaimer: Modifying BIOS/ complementary metal oxide semiconductor (CMOS) settings incorrectly can cause serious problems that may prevent your computer from booting properly. Microsoft cannot guarantee
that any problems resulting from the configuring of BIOS/CMOS settings can be solved. Modifications of the settings are at your own risk.



If the issue persists, I would suggest you to post your query in
TechNet forums, where we have support professionals who are well equipped with the knowledge on Hyper-V to assist you with the appropriate details.




Regards,

Nikhar Khare

Microsoft Community - Moderator

 

Enabling Hyper-V causes Windows 10 unable to boot

I'm having issues enabling Hyper-V in the "Add Windows Features" option in the control panel. I was hoping to increase performance with Google's Android Emulator for testing. Upon enabling Hyper-V, Windows
applies changes and resets. Windows is then unable to boot after this. Previously I had thought it may have been conflicting drivers from Virtualbox. After the last attempt, I was unable to use system restore or boot into Safe Mode and had to clean install.

I clean installed Windows 10 and installed windows updates and graphics / chipset drivers and tried to re-enable Hyper-V again. I also tried disabling "Fast Boot" in control panel at this time after reading
it may cause issues when enabling Hyper-V. I ran into the same problem but thankfully was able to boot into safe mode and windows successfully rolled back the feature and then booted normally.

I have the virtualization option enabled in BIOS. According to systeminfo, I have the requirements for Hyper-V AFAIK.

systeminfo command reads as follows:

• VM Monitor Mode Extensions: Yes
• Virtualization Enabled in Firmware: Yes
• Second Level Address Translation: Yes
• Data Execution Prevention Available: Yes

OS and Hardware:

• Windows 10 Enterprise
• MSI x470 Gaming Plus
• Ryzen 3 2200g

Any help would be greatly appreciated. Let me know if any additional information is required.

 

How to enable Hyper V windows 10

fwiw;

Operating System Requirements

The Hyper-V
role can be enabled on these versions of Windows 10:

• Windows 10 Enterprise
• Windows 10 Professional
• Windows 10 Education

The Hyper-V role cannot be installed on:

• Windows 10 Home
• Windows 10 Mobile
• Windows 10 Mobile Enterprise