Windows 10: error code 2000-0151

Hello


I have error code 2000-0151 From the information I got is that very serious How can I recover may information.

:)

 

Persistent SMART error on cloned drives (Error code: 2000-0151)


I am on my 4th SSD in my Windows 10 laptop that has been getting SMART error 2000-0151. We have replaced the motherboard, the SSD, and the connector cable between the SSD and motherboard.

One thing is that I've been using Macrium Reflect to clone the drives. The new drives work for a few days with no errors, then I start getting the SMART warnings. I'm wondering if the cloning process I'm using could be causing this (and if so, any advice for avoiding/fixing the issue), or whether it's possible that I'm just having a string of bad luck with these drives.

These are WD SSD drives in an Alienware laptop. It's still in warranty and they said they will probably replace the entire laptop at this point.

 

Error Code 2000 - 0141

Hello,

Thank you for posting your query in Microsoft community.

I would require more information to help you better.

• 
  What is the make and model of your computer?
  
• 
  Do you remember making any changes to the system?
  

From the error code 2000 - 0141, it appears that, this problem may occur if the hard disk drive in the computer is damaged or corrupted.

If you have any external hard disk plugged into the system, I would suggest you to remove it from the system and then boot to the system and check whether the issue is resolved.



Reply with results and necessary information to help you further.

 

Windows 10 and Ms Works 2000

Hi Spencer,

Thank you for posting your query on Microsoft Community.



Please reply: Did you receive any error message? If yes, kindly respond with the error message and error code.



We would appreciate if you tell us about your issue briefly. However, I would also suggest you to follow the steps below and see if it helps:

• Right click on Microsoft Works 2000.
• Click on Properties .
• Go to the Compatibility tab.
• Click on Run this program in compatibility mode and select the previous version which worked fine for you.

Awaiting your response.

Regards,