Windows 10: Far Cry 5: any reliable cheat for captive sequences?

I was enjoying FC5 until I met the first of I believe 9 unskippable capture sequences, which seem to be a time-limited spray & pray, run & gun setup.

One or two I can hold my nose and grind, but nine! I gave up in disgust a few months ago. I'd like to play it thru sometime tho, cos there's a lot to like in the other 99% of it.

I'm well used to using mods for games, but I've avoided cheats so far because of some warnings I read about they being suspect, eg possibly with malware attached.

So I'm looking for cheat sources you can recommend as having a good reputation—better still of course if you can recommend a cheat for my specific need—to skip or breeze thru the captive sequences.

:)

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

language key sequence "Ctrl + number" are missing for selection for some language input.

Hi Jzimy,

One of the possible reasons why your language key sequence are not working properly can be due to the keyboard settings of your device. To help us determine the appropriate troubleshooting steps, we’d like to ask the following
questions:

• What is the build and version of Windows 10 that you’re using on all of your devices? To check, type winver in the Search box and send us a screenshot of the information window.
• What application are you using to bind this key sequence?
• Have you made any recent changes before you encountered this issue?
• What troubleshooting steps have you done so far?

We look forward to your response.