Windows 10: Getting BSODs every now and again when booting the computer

Hello, I have been getting BSODs when booting up my computer. Usually it happens and then the computer shuts down, but works normally if I turn it on again like in most of the dumps here. Sometimes it boots up normally. Sometimes it happens if I try to restart it last time it created the dump 082622-22140-01.dmp. When I boot up the computer it also usually shows a screen with the ASUS logo, it loads for a bit then either boots up normally or gets a BSOD. The BSOD codes I've been getting have been most consistently SYSTEM SERVICE EXCEPTION KERNEL SECURITY CHECK FAILURE MEMORY MANAGEMENT

:)

 

ughhh! BSOD on boot

I guess my computer BSOD on boot right before getting to windows. not sure what the problem is though, everything is stable.

It gave me a list of two files in windows that could have caused the problems

 

Unable to boot the computer.

Hi Samid,

Thank you for posting your query on Microsoft Community.

Before we proceed, we would require more information to assist you further.

• 
  What is the make and model of your computer?
  

I suggest you check if you are able to boot into Windows Recovery Environment using installation media. Follow the steps provided below and check.

• • Insert the installation USB and boot Windows 10 from it.
  • In the ‘Windows setup’ page select the ‘language to install’, ‘Time and currency format’ and the ‘keyboard or input method’ and click on ‘next’.
  • Click on ‘Repair your computer’ and select ‘Troubleshoot’.

Check if you are able to boot to this window. If you are unable to boot to this window, I suggest you to contact the manufacturer and check.

Hope this information is helpful. Reply us with this information to assist you further.

Thank you.

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.