Windows 10: Hard disk error write protected. Try some solutions and they don't suc

I have this error on external hard drive.access denied.Recognize the hard drive I can navigate on it but I can't write or delete. Already try the administrator permission options for full control and it doesn't work.In the disk manager, "read only" appears.I can apply changes to be able to have the disk with total control without affecting files because they are more than 600GB of occupied space.

First capture shows the partitions.Second folder shows that I cannot modify the drive letter ..Third capture shows the main folder that contains more files.







:)

 

The Disk Is Write Protected - How To Remove Write Protection

Hi Fernanda,

Thank you for writing to Microsoft Community Forums.

In regards to your concern, please help me with following questions:

• Is the Hard drive external or internal?

You can try following steps and check if that fixes the issue:

1. Run Virus scan on the Hard Drive.
2. Perform check disk commands on the Hard Disk to fix the Disk errors.

Refer to this article.

Note: Remove all the external devices before performing check disk.

Data Loss Disclaimer:

While performing these steps there might be a risk of data loss. You may take a backup of the data before performing the steps.

Hope it helps.

Let us know if you got the help you needed by clicking Yes or No.

Rohit Raina

Microsoft Community - Moderator

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Gettign error "device is write protected" for External Hard drive in Windows 10

Hello Neil,

Thank you for contacting Microsoft Community.

We understand the inconvenience you have experienced.

Are you getting the same error when you access the External Hard drive on another computers?

When you see the message "Device is Write Protected", then it indicates that you have limited set of privileges for performing operation on the Hard disk. In simple, you're not allowed to write the drive, apart from reading it. This because the drive is
write-protected. Suggest you to try with the below steps and check it they help you.

1. Right-click on Start button and select Command Prompt(Admin).

2. Type diskpart and press Enter.

3. Now type list volume and press Enter. Now see the volume number the external drive.

4. Then type select volume #, where # is the number of the drive which is showing "write-protected" error. Example,
select volume 3.

5. Type attributes disk clear readonly and press Enter.

• Executing the above command line will reset the Hard drive USB's properties by clearing the Read-Only behavior, so that it is no longer read-only.

6. Type exit and press Enter. Now check if it allows you do access the drive for writing the content.

Keep us posted if you require further assistance.