Windows 10: Has anyone cloned ver 2004 using Macrium reflect?

Macrium Reflect fails with "insufficient Space" message when I try to clone my Win 10 version 2004 system disk.

I have regularly cloned my SSD system disk in the past, about monthly, writing over previous clones on a loose SSD. Last successful clone was of version 1909 on 22 May, anticipating the update.
My system disk is an internal 450 Gb SSD card that contains 180 Gb of files (GetFolderSize). This much has been successfully written to 250 Gb Drives in the past.

None of the 250s nor a pair of recently purchased, clean 500s will work with ver 2004, I tried them all.

Reflect was removed, a fresh download procured, and installed - same problem.

With only a free version, I cannot contact Macrium. If this is a ver 2004 problem, maybe somebody with a licence can tell them.

:)

 

Has anyone cloned ver 2004 using Macrium reflect?

Macrium Reflect fails with "insufficient Space" message when I try to clone my Win 10 version 2004 system disk.

I have regularly cloned my SSD system disk in the past, about monthly, writing over previous clones on a loose SSD. Last successful clone was of version 1909 on 22 May, anticipating the update.
My system disk is an internal 450 Gb SSD card that contains 180 Gb of files (GetFolderSize). This much has been successfully written to 250 Gb Drives in the past.

None of the 250s nor a pair of recently purchased, clean 500s will work with ver 2004, I tried them all.

Reflect was removed, a fresh download procured, and installed - same problem.

With only a free version, I cannot contact Macrium. If this is a ver 2004 problem, maybe somebody with a licence can tell them.

 

Has anyone cloned ver 2004 using Macrium reflect?

Should work fine, I have successfully imaged and restored my 2004 system disks with Macrium Reflect Free. I don't use cloning as a rule, but I can set up and test that in a VM with a pair of .vhdx virtual disks....

 

Attempted cloning a WD 8TB usb hard drive to another WD 8TB usb hard drive using Macrium Reflect.

Hi DennisCPA

i don't know of a maximum size (nor can i find it mentioned), largest i have cloned is 4TB.

when i last had a clone fail, whilst checking connections of the destination drive i put it in a different port and it worked (i didn't investigate further), suggestion, check destination drive connections or try a different port

you may get a better solution if you ask in the Macrium reflect forums

Macrium Support Forum