Windows 10: Having endless problems with my system, seems like an endless loop.

As of around the start of the year, I have been having problems with my PC. It started with my PC turning itself off whenever I'd load up a game, this was duo to overheating. However, that problem seemed to just stop happening as of recently and it has moved onto endless freezing when I boot up my system and when everything is loading into the desktop, but once it gets running it's alright. It's alright until I do something it doesn't like and I receive a BSOD message, I usually receive "Unexpected Store Exception" or "Critical process died", where I had to restart my PC and go through the freezing again. The amount of freezing has gotten to the point where it can take 30 mins to 1 hour to just be able to begin doing anything. I recently ran a "Hitman" virus detector as well as an ESET full scan, so all the malware SHOULD be gone. For some reason my PC will not allow me to reset it, install a new Nvidia graphics driver (or open the Geforce experience), and it is not allowing me to open AVG Tune up. I've tried installing the latest graphics driver manually but that also just comes up with an error. Any help or advice would be appreciated, if you need logs just let me know, I've ran the scan in the forum post rules.

Many thanks.

:)

 

Windows 10 endless loop reboot

Hi,

• Have you checked if the hard disk is set as first boot device in the BIOS?
• Which version of Windows is installed on the computer?
• What did the HP supported suggested you to fix the issue?

I suggest you to follow the steps provided in the following article and check if it helps.

Windows 10 endless loop reboot

If the issue persists, please get back to us with the more information about the interaction with HP support and the outcome of the issue.

 

Windows 10 update problem - endless loop

No this solution did not solve the problem. I inserted the installation media but it did not work, I was just thrown into the endless loop again. Any more suggestions?

Thank you

 

PC goes into an endless BOOT loop


Boot loop
Dell Inspiron 530
Windows 7 Home Premium 32bit
AMD Athlon 64 dual core
4GB DDR2
EVGA Graphics Card
PC showed no sign of powering on,
Removed graphics card
Disconnected HDD and DVD/CD ROM
Tested the power supply unit with multi meter all voltages are OK
Removed CMOS battery and replaced with new battery
Replaced the graphics card and connected the HDD and the DVD/CD ROM
The pc powered on and could hear the beep as normal, had the message Diskette drive 0 seek failure, went into the BIOS disabled the Floppy A [1.44, 3.5 in.]
Set the BOOT device priority to;
First Hard Disk
Second CD ROM
Third Removable
Fourth Hard Disk although there isn’t a fourth HDD
I am confused as on the HDD Group Boot Priority it states “1 3rd Master: WDC WD5000AAKS-75YGA0" which is my only HDD that has ever been installed with Windows plus data and applications.















The problem I have now is that the BOOT sequence goes into a loop and does not load Windows but instead after each loop the screen shows that there is NO SIGNAL and the pc starts again and the splash screen displays but the pc goes into the same loop over and over again with no other message.
Any help with sorting this endless loop and getting the pc to load Windows would be most appreciated. *Wink