Windows 10: HDMI Splitter?

Hello! so i dont know if anybody can help, if its a windows thing or hardware but ive got a couple more 1080p monitors on the way to setup triples and i ordered a hdmi splitter to connect them all to one port but ive just gone to test it on some monitors ive got at home and they turn on but show up cloned and in display settings only show as 1 monitor which means i cant extend them or create a res in nvidia control panel? Where have i gone wrong!?

Here is the splitter i bought:

https://www.amazon.co.uk/Splitter-N...ayer+HDTV&qid=1577653534&s=electronics&sr=1-1

submitted by /u/Zypher6
[link] [comments]

:)

 

HDMI Splitter

A splitter will not work it only shows the same image on two screens.

Your graphic card needs to have 2 HDMI ports.

 

HDMI Splitter

Hello,

I just purchased an HDMI splitter to connect to a monitor and projector. I want to be able to separate the two displays, but the computer won't detect a second display. Is there a way to resolve this? I only have one HDMI output on the pack of my computer.

Thanks,

Joel

* Moved from Insider

 

Issue HDMI Splitter(1 male to 2 female). Working,but not really

I am using a HDMI splitter (1 male to 2 female,the one in the image) to display the same image on 2 monitors,both with a 1080p resolution.One of them a graphic tablet display,the other a regular monitor.





I was able to get it working,but once one of these scenarios occurs ,the resolution changes into 640x(and stays locked in the settings,I can not change it.)

• one of the monitors is turned off.
• male HDMI which is plugged into the computer is unplugged ,and plugged back up again.
• When the computer goes into standby.

Basically the computer can't seem to save that state,and turns to 640x



The only solution I found is to manually ,disconnect the graphic display tablet from the splitter,leaving only the monitor connected to the splitter.Then disconnecting the splitter from the computer and connecting it back in.After that connecting the graphic
display tablet to the splitter.

Doing this is quite the unnecessary hassle.

So my question is,if there's a way to save the 1080p state,and not having it changing the display resolution every time the monitors are turned off.

Thanks in advance