Windows 10: Help with FydeOS boot problems.

FydeOS does not create its boot files in the ESP partition and in EFI folder.And thus, after a "successful" installation, its boot option loads the next item in the boot sequence and also when i select "dont create boot option" and tick the "use rEFInd", refind also doesnt get installed. The OS Part is ok, and has its own files. part where the OS was installed [ROOT]But the EFI partition does not have the boot files for the FydeOS.and so it never boots into fyde, anyone having the files? or just upload a screenshot of the EFI folder!Please Help.

:)

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.

 

Windows 10 1709 System Restore problems...

That seems to be an attempt at Option 2 in the tutorial, which requires you to
a. Boot to a command prompt (Did you?)
b. You then seem to be mixing steps 3,4 and 5, thus your command is incorrect.

I suggest Option 1 is easier.

If you still have problems, please repost listing each specific step and saying which option from the tutorial you are using. Thanks.

 

PC wont boot up (No POST, No Video)

I recently installed a new Asus M5A99X Evo r2.0. The motherboard green LED lights up and the case and cpu fans spin. But there is no video when its hooked up to my monitor.

Steps that i have tried:
http://www.tomshardware.com/forum/261145-31-perform-steps-posting-post-boot-video-problems

Made sure all connections are properly connected.

Flashing the CMOS

Tested the PSU

Followed all steps in the user manual

If there are any links that you guys can point me to or suggestions that could help it would be highly appreciated. Thank you