Windows 10: Hewlet-Packard - USB 4/8/2019 1.0.0.237 keeps reinstalling on Windows 11

Hewlet-Packard - USB 4/8/2019 1.0.0.237 keeps reinstalling, apparently successfully, every couple of days. How do I make it stop? The constant updates are bad enough without redundant reinstalls.

:)

 

Total identified Windows installations: 0

PLEASE HELP!!

I have the same problem with the identified windows installations 0

And im following your steps and when i reach step 4 it tells me:

The store export operation has failed.

The requested system device cannot be found.

What shall I do?!!!

After diskpart list I have only 1 desk which is the USB, and 1 volume and 1 partition!!!

 

Moving to RAID 0 - INACCESSIBLE_BOOT_DEVICE


I am converting an existing Windows 10 Pro laptop to RAID 0 - and I keep getting to the final boot where it says INACCESSIBLE_BOOT_DEVICE. What am I doing wrong? The laptop has two 1 TB Samsung 850 SSDs that are identical. Laptop is a HP Zbook 17.

Here are my steps:

1. Made a good System Image of C: drive on separate external SSD drive connected by USB. D: drive didn't have anything on it to be saved.
2. Used Win 10 Pro DVD to delete all partitions/format drives.
3. Went into BIOS and changed from AHCI to RAID, and also to turn on ability to do Control-I to get to Intel RST ROM.
4. Rebooted, did Control-I, created a RAID 0 of the two disks.
5. Rebooted, installed Windows 10 fresh. Verified it would reboot on its own.
6. Rebooted, went into Repair on Windows 10 DVD. Selected external SSD image to do image restore from.
7. Rebooted - verified on Control-I that the RAID 0 array is listed as "bootable"
8. Rebooted - get INACCESSIBLE_BOOT_DEVICE.

The place it dies - I see the little Windows 10 blue window, and the spinning circle at the bottom - then I get the blue screen with the message.

I think I listed everything I did - what am I missing?

 

Help with USB VID_0000&PID_0002\6&32FA202A&0&8

Hi Nikolaos,

We suggest that you apply the troubleshooting procedures below:

Method 1: Run Hardware Troubleshooter
to diagnose issue with hardware if there are any on your computer. Follow the steps:

• Click Start or press Windows logo and go to
  Settings
• Search for troubleshooting and select Troubleshooting
• Go to Hardware and Sounds
• Select Hardware and Devices and click on next, then follow the on-screen instructions.

Method 2: Disable and re-enable all the Universal Serial Bus controllers (USB) controllers.The USB controllers represent the USB ports in Device Manager.

To disable and re-enable the USB controllers, follow these steps:

• Open Device Manager
• Expand Universal Serial Bus controllers.
• Note: You might have to scroll down the list to find this item.
• Right-click the first USB controller under Universal Serial Bus controllers, and then click Uninstall to remove it.
• Repeat the above step for each USB controller that is listed under
  Universal Serial Bus controllers.
• Restart the computer. After the computer starts, Windows will automatically scan for hardware changes
• Reinstall all the USB controllers that you uninstalled

Let us know how it goes.