Windows 10: Hey there, trying to boot from a USB device and saw this"uncommon" blue screen, problem...

submitted by /u/FLYING-iPHONE
[link] [comments]

:)

 

Startup Blue Screen

Hi Jon,

Startup blue screen error(s) can occur if a problem causes your PC to shut down or restart unexpectedly. It could be due to the following:

• Outdated device software drivers
• Corrupted Windows update system files
• Software/Security conflicts

We would like to know some information:

• Did you get any blue screen stop error codes?
• Have you tried booting in Safe mode?

We suggest that you check this
article about troubleshooting blue screen errors and follow the troubleshooting steps provided there.

We will wait for your response

 

USB ports fail, then blue screen of death on three Windows 10 computers -- Can this be fixed or is this caused by a virus?

Hi Grace,

It's possible that certain drivers, such as USB and other device drivers are causing blue screen errors on your PC. Another factor is due to a conflicting third-party software. Now, before we get into the solution, were you able to boot your computer normally
or can it boot to the desktop screen? If yes, then we suggest that you run the
Hardware diagnostic tool on your PC. Just type troubleshooter on the
Search box, press Enter, then look for
Hardware and Devices, and click Run the troubleshooter.

If the troubleshooter didn't resolve the port issue, then might as well you update the USB driver, and the BIOS firmware of your computer.

In addition to that, if you're still getting a blue/black screen error after performing the recommended steps, then we suggest that refer to the troubleshooting steps from these articles:

• Troubleshoot blue screen errors.
• Troubleshoot black screen or blank screen errors.

Let us know the outcome.

 

Booting from USB on x38 Motherboard, NOT?

See sys specs... ASUS ROG x38 motherboard, flashed to x48 Rampage.

In BIOS under "Boot Device Priority", I select and of the 3 boot device slots, and no where do I find an option for USB, these are the only options in each:

• 1st floopy drive
• HDD: P0-WDC WD2500KS
• ATAPI CD-ROM
• Disabled

Is there a place in the BIOS to enable boot from USB?

It's AMI, says v02.61 on the BIOS screen