Windows 10: How do I protect my ports

I tried to install webdriver for chrome but it shows up a message that I Should protect my ports so how would I know that which of my ports are unsecure and how to protect them.



:)

 

Password Protect for USB port.

Hi,

I will certainly help you in password protecting of USB port.

Please follow the steps:

• 
  Open Run command (Windows logo key + R key) and type
  gpedit.msc
  
• 
  Click on computer configuration > administrative templates > system > removable storage access
  
• 
  Double click on All Removable Storage classes: Deny all access and enable it.
  

Note: If you enable this policy setting no access is allowed to any removable storage class. If you disable or do not configure this policy setting, write and read accesses are allowed to all removable storage classes.


Please get back to us if you still face any difficulty with windows 10.

Thank you.

 

USB Port Oddities


Ok, let's see it with pictures step-by-step. First right-click on the USB device and select Update driver software:





Then select Browse my computer for driver software (LAST option) :





The select Let me pick from a list of device drivers on my computer (LAST option) :





Then select the standard driver from the list and click next:





Click next/OK as required to complete installation. Repeat the steps for all Intel USB devices. Finally click on each USB root device and press DEL to delete it, reply YES when asked. After deleting all USB root devices restart the computer.

I hope this is detailed enough...

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".