Windows 10: How do I reset my computer to switch the os to my ssd

How do I rest my computer so I can download the os on my ssd

:)

 

power/reset on the same switch?

ya a few cases are made with just the one switch, they figure since the on off switch will also reset it they dont need the other switch.

just leave the reset pins unconnected and hook the power switch normally. if you bump and release the power switch it will reset the computer or push till it clicks and it will stay off.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

After hard reset, OS disk showing no volumes/partitions

Hi everyone,

I've searched high and low on Google for the specific issue that I'm having, but I can't seem to figure this out.

About a year ago, I built my own computer. I have my OS (Windows 10) installed on a Plextor M6 256 SSD. Today, for about the fourth time in a year, my computer became unresponsive during normal use. After a forced hard reset, I was taken to a black screen with the 0xc00000e error, telling me that a required device was inaccessible. After a quick Google search, I found many answers saying that this problem was because of a corrupted boot record.

I followed the steps recommended by Microsoft. First, I attempted automated startup recovery. This didn't work. Then I attempted to use bootrec to fix the problem. This resulted in the tool telling me that no Windows installations were detected.

I decided then to open diskpart. The disk itself was detected, but whenever I listed volumes, nothing showed up for that disk. No partitions or volumes were listed.

I've since recovered the drive by flashing a Clonezilla image that I had as a backup, so everything is up and running now. However, I am curious as to why this problem keeps happening. I've downloaded the diagnostic tools from Plextor for my disk, and it says that everything is fine. I've also run a Windows memory diagnostic, which has returned no errors.

My assumption is that the hard reset is causing some kind of partition table corruption. But, that still leaves the issue of why the computer is freezing up to begin with unsolved. Any suggestions/possible causes to investigate would be much appreciated!