Windows 10: How to remove the "cursor speed" in Mouse Setting

I remember in my old PC (Windows 10) that there were no Cursor speed in the page of cursor speed, you need to get into additional mouse options to change the dpi. However, in my new PC (window 10), the there is a cursor speed in the mouse setting page, so I do not know which number should I adjusted can I change my windows in the old version or can i turn off that "cursor speed panel" in this page, so I can have the same interface of mouse setting page?

Screenshot:

New PC: https://ibb.co/Pcn19RQ

Old PC: https://ibb.co/Z8GN6FM

submitted by /u/ITL08UW
[link] [comments]

:)

 

Click and drag keeps speeding up on touchpad

Hi,

Do you face this issue while moving the mouse cursor normally on the desktop screen?

If yes, I suggest you to follow the below steps in order to slow down the mouse cursor speed.

• Go to control panel.
• Click on mouse.
• under pointers options tab adjust the pointer speed, click
  apply and ok

let us know the status of the issue to assist you further.

Thank you.

 

No mouse cursor

Hi,

It is possible that the system did not recognize the mouse of your computer after it booted up. This can be the reason why you do not see the mouse cursor. Kindly perform a power cycle to refresh the power of the computer. To do this, follow these steps:

• Shutdown the computer.
• After shutting it down, remove the battery (if you're using a laptop) and disconnect the computer from the charger.
  
• Wait for 1 minute.
• After 1 minute, attach the battery and turn on the computer.
• Check if you will see the mouse cursor.

Let us know how it goes.

 

Change the cursor speed for Precision touchpad

Hi,



Thank you for writing to Microsoft Community Forums.



I understand that you want to set the cursor speed value more than 20. The valid range of values for the registry key that you want are trying to change is 0 to 20, with a default value of 10.



Note: Important this section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow
these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs.



Follow the steps to take backup of registry.




For more information, you can refer the article
Precision touchpad tuning.



However, to increase the cursor speed you can change the mouse settings in Control Panel. Please follow the steps mentioned below:

1. Press Windows key + R, to open
   Run dialog box.
   
2. Type control and click on
   OK.
   
3. Select Large icons from the drop down for
   View by.
   
4. Click on Mouse.
   
5. Navigate to Pointer options tab and under
   Motion, move the slider towards right to change the cursor speed.
   
6. Click on Apply and OK.
   

Please reply with the status of the issue, we will be glad to help you further.



Regards,

Nikhar Khare

Microsoft Community - Moderator