Windows 10: I can't use the Chkdsk command; and I've enabled BitLocker, on Windows

Hello, I have a HP Windows 10, and I recently Used the CHKDSK Command, and it took a long time, and it finally ended. But, I followed bom omb's directions, but it says this Hard Disk is Raw, this can not be performed on RAW Drives, and I used sfc /scannow, and it did not work either.

:)

 

BitLocker won't enable on Windows 10 after update on Aug 9

Hi Brenda,

I would be happy to assist you.

Before I assist you I would like to know the information below,

• 
  Do you have a Windows 10 copy of the operating system?
  

I suggest you check whether the Bit locker is ON or OFF using the steps below.

Can you verify if BitLocker is enabled or disabled on your device? You can Enable/disable BitLocker by going to Desktop and follow these steps:

• 
  Swipe Right to Left to bring up the Charm.
  
• 
  Choose Settings.
  
• 
  Choose Control Panel.
  
• 
  Select BitLocker Drive Encryption.
  
• 
  Verify whether BitLocker is on or off on each device.
  

Also I suggest you to enable the WinRE so that you can enter the bit locker key and proceed.

When WinRE is disabled, you cannot enable BitLocker, and you receive an error message that resembles the following.

This PC doesn't support entering a BitLocker recovery password during startup. Ask your administrator to configure Windows Recovery Environment so that you can use BitLocker.

The solution would be to manually enable the windows recovery environment:

• 
  Copying the winre.wim file from c:\windows\system32\recovery\ to a folder on a recovery partition. (The partition need to have a drive letter at this point.)
  
• 
  Set the RE Image path. Example: reagentc /setreimage /path r:\recovery\windowsre
  
• 
  Enable RE with command: reagentc /enable
  
• 
  (You may remove the drive letter for the recovery partition after you have done this.)
  
• 
  Bit locker will be enabled.
  

If the issue still persists, suggest you to post your query on the below link.

https://technet.microsoft.com/en-us/library/hh831507(v=ws.11).aspx

Hope this information was helpful and do let us know if you need further assistance. We will be glad to assist.

Thank you.

 

GPU-Z what command line parameter ?

Suggestion: /? (-?) and /help (-help) command-line arguments to show a list of all possible arguments in a small window. *Smile

 

Bitlocker

Hello Nandana,

To enable BitLocker on your computer, you follow the steps below:

• Sign in to your Windows account with an administrator access.
• Press the Windows key.
• Type and enter BitLocker.
• Click Turn on BitLocker.
• If the system is asking to sing in to administrator access, please do so.

For additional information about BitLocker, we suggest that you check the frequently ask question on this
link. The link provided applies to Windows 8.1 to higher version.

If you have other concerns, don't hesitate to reach us.