Windows 10: I have 2 ANT usb sticks, both visible in device manager, but windows will not recognize...

Where is the correct driver for one of my 2 usb ANT sticks? libusb-win32 devices Dynastream Innovations, Inc. USB\VID_0FCF&PID_1009\085 was configured. Parent Device: USB\ROOT_HUB\4&209dff44&0Any help would be appreciated,Thank you,D.

:)

 

Ant+ Stick only works in USB Hub

I have a, in my opinion, strange issue.

I use a Garmin Ant+ stick to collect cycling data while on a stationary trainer. I had purchased a Lenovo Yoga early 2018. It only has 1 usb port so I purchased a 4 port USB hub so I could increase my number of ports a second screen and hardline to ethernet.
I plugged in my Ant+ stick and the computer did not respond. Downloaded all the proper drivers googled the heck out of it and came up empty. I assumed the Ant+ stick some how went bad. I purchased a new one. When I plugged this in, the computer responded,
but it showed the device not recognized (the last USB you plugged in malfunctioned and Windows did not recognize it). Eff.

By sheer frustration, i went to my desk and plugged in my USB hub. I said what the heck and plugged in the Ant+ stick. Would you believe me if I told you that I now have two Ant+ sticks that work completely fine? Has anyone come across this before? Why
does this device work fine when plugged into the USB hub and fails miserably when directly plugged into the USB port? I will admit I had to make some changes to get the USB hub to work, but I can't remember what was done. I've got no problem using the hub
while I train, but I just don't understand what's going on.

Thanks in advance.

 

USB stick only visible in device manager

Dear forum,

I have a USB stick (corsair voygaer GTX, it's an ssd in usb stick format). It has worked flawlessly a week ago and today when I plug it into several different PC/laptop it only shows up in "securely remove" and as a a SCSI disk drive. (not sure if that was like that before). It does not show up under USB -> USB Mass storage device. It also does not show up in disk management.

Any steps I can do to make this work again or is the hardware somehow dead?

 

USB stick previously used as a boot stick for Killdisk not recognized

Try method 2 under Windows 7 8 10 here:
Free to Remove Readonly Attribute in Windows

Method 2: Clear readonly status with Diskpart

In Windows 10, 8, 7 OS, you are also able to run Diskpart in Command Prompt to clear read-only attribute on any partition on your computer. You can follow the tutorial below:

Step 1. Open Command Line and type Diskpart
Step 2. Type list disk
Step 3. Type select disk (disk number)
Step 4. Type attributes disk clear readonly





Then try Clean