Windows 10: I have one Admin account and 4 User Accounts! in Windows 10

How can you merge the 4 user accounts in one because of many times reinstall windows and restore from my external Hard Drive and created all these accounts, I just want to keep one and transfer all data and without having 2 - 4 repeated ones; Of course I would like to keep my admin account as it is. Do you have any program that will do this automatically, I am not to proficient in the knowledge of managing this accounts. Your help will be gratefully appreciated.


For my previous question also would like to know if Microsoft have a section that I can access and they can explain how to do it step by step with audio visual guidance.


JJL

:)

 

Strange Windows 10 User Account issue.

Unfortunately I had done those steps numerous reboots, it just, reappears for no good reason. The base account isn't even a Microsoft account, it's a local account.

I haven't quite tried the built in administrator account on W10, but so far in my experience on my own computer, the built in account seemed to have absolutely no more control than I did on my own.

It's just strange, I go in, it warns me twice about deleting the account, then it's gone. Reboot, and it's back?

EDIT: Just to specify, both command line and Netplwiz both say only HIS account exists on the computer, it doesn't list this rogue account. This is what I meant in my first post about the fact that even Windows doesn't seem to believe it exists, HALF the time. *Frown

 

Strange Windows 10 User Account issue.

Look at this thread,How to Delete a User Account in Windows 10, it may help. You can try the various methods.
Make sure you are using an administrative account when removing the account or log on using the Administrator's account.

Or, if you are patient and know what you are doing, manually remove it.

Either way, Goodluck.

 

My admin account switched to a user account!

The first of the many diagrams in this thread show that the link Sign in with a local account instead is displayed for the account that is currently logged on and so the reversion procedure might work for this account. For normal circumstances, that would initiate the conversion back to a local account for the user account currently logged in - see my 23rd & 26th September 2016 posts in revert to local account from one converted to MSAccount. I have no way of knowing how Windows will react to an attempt to use this procedure for the Built-In Admin account and I do not know if that link Sign in with a local account instead will be displayed or not.

I think I side-stepped this issue by suggesting that that

• An extra password-protected Admin level account is created, and
• The Built-In Admin is disabled, and
• The recovery attempt focuses on whichever existing user account remains active afterwards.

Personally, I would reinstall Windows 10 without even attempting this recovery. Installation takes very little effort once everything is backed up and the only necessary user interactions are right at the start & right at the end so it can be initiated before making a pot of tea. It took about 30, 60 & 90 minutes for each of my computers [the 30 minuter is 6 months old, the 60 minuter is 7 years old, 90 minuter is 12 years old].

Raner - I am trying to avoid sounding like I am nagging you into doing a clean install.

• Once you have recovered the existing user account you can attempt to re-enable & remove the MSAccount link from your Built-In Admin if that link appears in Settings, Accounts.
• Bree says it cannot be done and I think the same but I have never tried - I have never been able to get to Settings using the Built-In Admin because it cannot run any Windows 10 Apps so I do not know how it can be done [but the diagrams in Bree's link shows that those users got there].
• Even though I have the safety of having created two spare password-protected Admin accounts I would not want to know that my Built-In Admin was sitting in the background but unable to help me if my other accounts were corrupted.

Denis