Windows 10: Im formatting my pc for the first time and have a couple of doubts

1-Since i have only one usb i was wondering if i can make a partition with bootable windows and the other with info or i have to upload the info to the cloud.

2-how much space should i give to the windows partition?(i want to have the desktop and everything about users in another partition so its only the SO).

3-any tips or things i should know before and after the reset?

Ty for reading

submitted by /u/Ruso-sama356
[link] [comments]

:)

 

Changing Time Format

Hi Mary,

There's a possibility that the set up time format in your computer Basic Input/Output System (BIOS) is military time. To have this checked, you can try to reset the time of your computer through Control Panel. See the steps below on how to do
so:

• Open Control Panel > Clock, Language, and Region >
  Change date, time, or number formats. This would open the
  Region window.
• From there, click on Additional settings at the bottom part. It will open the Customize Format.
• Click Reset; then, OK.

The steps should work; however, if not, we suggest that you contact manufacturer and have the BIOS time checked.

Let us know what happens after doing the suggestions .

 

Windows Format Configuration (time)

Hi Joc,

Thank you for posting on Microsoft Community. I will certainly help you with this.

I suggest you to try the below given steps and check if it helps you to change the time format.

• Press Windows key + X key, clicking Control Panel, clicking
  Clock, Language, and Region, and then clicking
  Region.
  
• Click the Formats tab, and then, in the
  Format list, select the Match Windows display language (recommended)
  under Format.
• Check if the h: mm: tt is available under Short time and
  Long time format.

Please post back with the results, we will be glad to assist you further.



Thank you.

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!