Windows 10: Internet drops for a few minutes on one device.

Every couple minutes my PC drops internet connection for a few minutes and then comes back briefly. When I run the troubleshooter I get the following message: "Your computer appears to be correctly configured but the device or resource www.microsoft.com.com is not responding." The network icon also shows that it is connected.UPDATE: I installed a wireless network adapter and have the exact same problem. So it isn't my Mobo NIC or drivers.Here is what I have tried:Replacing the ethernet cableRunning network troubleshooterRunning Windows Update troubleshooterRunning network adapter troubleshoo

:)

 

Internet connection dropping

I had already tried this and it did not work. I did find an updated driver for my adapter (Realtek) and so far no more problems. Thanks for the suggestion!

 

Dropping off internet

Hi Amelia,

It is possible that your
Network Components
were corrupted during the update or your
drivers
were
outdated
causing your network connections to drop off. We suggest that you perform these
methods of troubleshooting
and check if there are any changes:

Method 1: Update your drivers.

To know how to update your drivers, click
here.

Method 2: Reset TCP/IP

To do this, follow these steps:

• 
  Run
  Command Prompt
  as
  Administrator.
  
• 
  Run
  this command:
  
  • 
    netsh int ip reset
    and hit
    Enter.
    

Exit
Command Prompt
and
monitor your Network Connection.

Method 3: Disable auto turn-off of WiFi device.

Go to
Network and Sharing Center. At the
right pane, click
Change adapter settings.
Right-click
on your
connection name(WiFi name)
and go to
Properties.Click
the
"Configure..."
button and go to
Power Management
tab.Uncheck/disable
the
radio button
for
"Allow this device to turn off this device to save power". And then,
Restart the PC(Important).

Method 4: Reconfigure TCP/IP

To do this, follow these steps:

• 
  Run
  Command Prompt
  as
  Administrator.
  
• 
  Run
  these following commands:
  
  • 
    netsh int tcp set heuristics
    disabled
    
  • 
    netsh int tcp
    set global autotuninglevel=disabled
    
  • 
    netsh int tcp set global
    rss=enabled
    

Update us on how it goes.

Regards.

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.