Windows 10: Macrium in Startup

Does the ReflectUI.exe really NEED to be in my system Startup?

:)

 

Can't get GPU-Z to start with Windows 8.1 startup

I'm not sure how to do that. Could you list the steps for a noob?

 

Restoring Windows 10 Image using Macrium Reflect


In addition to the above. Here's my suggestion in step by step.
I assume you have Macrium Installed in your current HD and already made a backup copy.

1. Connect your new HD via USB port and boot up.
2. Run Macrium, click on Restore tab then select the Backup Image that you made to restore
3. click on "select a different target disk" then select your new HD as destination
   
   
   
4. Proceed to restore then Shutdown and disconnect the old HD and replace with the new HD
5. Boot up with your new HD.

 

windows 10 no advanced-startup-options, so no startup settings


when i did 1. 2. 3. steps i checked and problem was SOLVED
but after 4. 5. 6. 7. steps i checked and no advanced startup options again

1. Make a complete backup image of your current HD including all partitions to an external HD using macrium reflect . Once done, disconnect all USB devices from the PC. Assuming now you only have one HD connected to the PC which you will be installing Windows.
   IMPORTANT: Also create a Macrium Rescue disk to boot from later on.
2. Boot up your Windows installation USB/DVD. On the first screen, Hold SHIFT + F10 to open Command Windows then type:
   Diskpart
   select disk 0
   clean
   exit
3. Click Next, Choose Custom, select the unallocated partition then click Next (Do not format), when asked for Product ID key, click on "Skip this step"/"Do it later". Continue the Installation.
4. Once done. With the external HD connected, Reboot your PC with the Macrium Rescue disk, select the image that you created in step 1 as the Source.
5. Select your current HD/SSD as Destination disk
6. Restore only C: Drive to it. ie. overwrite the new C: Drive with your backup C: Drive.
   NOTE: See screen shot on how to perform this step
7. Disconnect all the external devices. Reboot. Windows should perform a startup repair.

till 4. step there was no windows 10 key activeted and problem vas solved
but after step 7 i checked key and it was not the same which i purchased, why did that change? i activated purchased key again.
so is the problem to be a windows 10 key on my pc?
or do some drivers prevent advancedstartup options?