Windows 10: Macrium Reflect home ver. 7 Question

I wound up with corrupted files some how and sfc scan or Dism command wouldn't repair them. I then went to restore with one of my backup images and the backup said it was corrupted the first time I tried to confirm it but then the second time I tried to confirm it it said it was good? Three different images I checked also, said they were corrupted the first time I confirmed but second time they said they were good too? Thanks for any input! *Smile Also, the first image that did that went on just fine with no problems.

:)

 

Macrium Reflect Question

Although the screenshots in the tutorial are from v6.2, they are still valid for v7.2. See Part Five:

Backup and Restore with Macrium Reflect


And if you have a spare drive you could swap in to temporarily replace the original, then you could run the test without needing to be quite so brave *Wink

If not, and you're not feeling brave enough yet, then instead of a Restore boot from the rescue media and run the Verify instead.

 

Macrium Boot Question

Macrium Boot Question

I use Windows 10 and a Macrium recovery program. My BIOS is set where the optical disk for CDs and DVDs are not set to recognize a CD/DVD disc as the first priority to boot from.

What are the steps I should take to make my Macrium Rescue Disk as being first to boot from?

Thanks,

Jerry

 

Restoring Windows 10 Image using Macrium Reflect


In addition to the above. Here's my suggestion in step by step.
I assume you have Macrium Installed in your current HD and already made a backup copy.

1. Connect your new HD via USB port and boot up.
2. Run Macrium, click on Restore tab then select the Backup Image that you made to restore
3. click on "select a different target disk" then select your new HD as destination
   
   
   
4. Proceed to restore then Shutdown and disconnect the old HD and replace with the new HD
5. Boot up with your new HD.