Windows 10: Main M2 SSD is not Primary Partition in Disk Management

Just as title says. Just checking my system for other reasons, and I noticed this.My main "C" M2 SSD, is not "blue" in disk management, the colour for Primary Partition. It's in green, as "Simple Volume". Sorry if this isn't the proper term in english, but I have my OS in italian.Is there anything wrong in this?



:)

 

W7 Hard drive partition issue

to get rid of that 100 meg windows partition that setup creates for you on a new install on a blank hdd:

- press shift+f10 when on the partition management screen in setup <-- this opens a command prompt
- diskpart <-- start the windows command line partition management tool
- list disk <--- list the installed hdds in this computer for the next step
- select disk 0 <- might have to replace 0 with the number of the correct disk
- clean <-- this will erase all data on the disk you selected one step up- dont use the wrong disk!
- create partition primary <- creates a primary partition taking up all space on the drive, adjust the command if necessary
- exit, exit to exit diskpart and the command prompt
- click refresh in partition manager and select your newly created partition and install to that

 

Migration from Hdd to m2.SSD

Recently I have purchased a new laptop (hp probook 450 G4) and a new original windows 10 home edition and now I want to upgrade my 1 TB Hdd to a new m2 ssd and my laptop supports another slot for the m2 ssd so I can run both
the m2 ssd & hdd at the same time but I will make the m2 ssd the boot drive and the hdd will be the data drive.
MY Question is how can I migrate system drive to the new m2 ssd without the need to reinstall windows or any other installed programs and there is another thing, when I checked the disk management I found 3 recovery partitions will I have to
migrate them too or I have to migrate the system drive only

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?