Windows 10: Multiple BSOD different error showing each time.

Hi folks, Recently I have been having issues with my computer, out of the blue it has just started randomly showing the BSOD, each time with a different issue. I have reset the computer & also checked for driver updates however can not seem to find anything out of the ordinary. Turning the computer is blue screened twice before finally deciding it was ok to boot up and since then has been running normal. I tried installing the WinDbg tool and having a read through however I cant make much sense of it.See belowBSOD #1************************************************************************

:)

 

7 different BSoD

Hey guys,

I have a serious problem. I make it as short as possible:

• system runs 100 % fine with the 10.12
• updatet to Catalyst 11.1 -> BSoD
• updatet to 11.1 Hotfix -> BSoD
• rollback to 10.12 -> BSoD
• removed ALL AMD files manually, installed 10.12 -> BSoD

• Temps are fine
• no sfc /scannow errors
• no chkdsk errors
• Prime, Furmark all fine
• regardless what driver I install -> BSoD
• I did no hw changes, no OC

Here are my BSoDs I receive:

• 0x0000010e
• 0x1000007e
• 0x0000007e
• 0x0000004e
• 0x0000003b
• dxgmms1.sys
• PFN_LIST_CORRUPT

They all refer to the GPU of course ...

From now on I receive a BSoD every time I try to play a game (especially BC2 and SC II) even if I completely remove the old driver and make a clean install.
Apparently the 11.1 damaged my system irreparable.

Any advice or info would be very much appreciated *Smile

 

BSOD random times different errors

 

Multiple BSODS with different errors, caused by ntoskrnl.exe

Wow thats a lot of usual causes!

Just to clarify / remove some things of that list, as mentioned the RAM has passed memtest multiple times, none of my hardware is OC'd, BIOS is fully up to date.

As far as I'm aware this is because its the single ram speed, and with it being DDR its 800*2=1600, I could be mistaken though?

As for the slots basically I was having BSOD's whenever any module was installed in one of the channels, so I had to move both modules over to the other channel, and this seemed to fix it, however I can move them back around to see what happens.

As for the memory I could have sworn I saw it on the supported list a while ago, ill check with the vendor of my PC.

Thanks for all the help

So whats the next step?