Windows 10: Need help plz with windows reset

Okay I tried to do a windows 10 reset advanced so everything removed a few weeks ago. It said a problem has occurred no changes were made. I shrugged it off and just didn’t reset my pc. Well fast forward this week I tried again same message (Keep in mind this msg appears like midway through reset like around 50%. So I tried to use a recovery drive with a usb. I used windows built in option downloaded the recovery drive on a usb. The tried to do a recovery drive reset instead. Same msg, but now I can’t access my windows interface. When I turn on computer it says No Bootable devide, when I plug it in it brings up recover pc from bootable disk or troubleshoot, click trouble shoot and it’s the regular ones you’d see. Also I can’t enter bios mode since I need a password and I made it like 3 years ago. The laptop is a we predator Helios 300.

submitted by /u/Dilpickle15
[link] [comments]

:)

 

windows xp installation and dual core am

could someone please list the steps they follow to install windows with a dual core processor and windows xp service pack to. I'm reletively new to amd dual core and i feel i'm missing a step. All help will be appreciated. thanx

 

Plz plz Help with my Nokia c7

Hi nokia my phone in a same condition no store, no sotial net plz help me. After hard resetting by three buttons (home,volume,camera) everything gone like ovi store, social, After hard reset went to s/w update and download the Ovi Store which was not in
the listed did the *#7370# still not there plz plz plz help me

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".