Windows 10: New hard drive and now stuck in BIOS

I just replaced my dying SSD with a new SSD. Just before I removed the old one I backed up all the data to an external drive. With the new drive in my PC, it isnt making that horrible noise it was before and seems well. Now however when I turn on the PC it goes and stays in BIOS. I'm assuming it is because the PC doesnt have windows anymore. So can I move the files from the external drive to my PC in BIOS. or so I need to install my old SSD and transfer the files directly to the new SSD?

:)

 

Help with external hard drive

Hi Debbra,

Welcome to Microsoft Community.

I appreciate your interest in windows 10 and also for trying the troubleshooting steps to fix the issue. I understand the inconvenience you faced. I will certainly help you with this.

I would suggest you to plug in hard drive then check in disk management you can see the drive or not.

Follow the steps to check Drive in Disk Management.

• 
  Go to the Control Panel then click on the
  Administrative Tools. .
  
• 
  Under the Administrative Tool Click on Computer Management.
  
• 
  Click on Disk Management and check the External Hard Drive.
  

Also check in BIOS whether External Hard Drive is listed or not.

For help with the BIOS settings, refer to the computer manual or contact the manufacturer.

If it doesn’t work then, I would suggest you to update BIOS for updating BIOS contact Lenovo Support.

Follow the link:

http://support.lenovo.com/in/hi/

Disclaimer :

Modifying BIOS/complementary metal oxide semiconductor (CMOS) settings incorrectly can cause serious problems that may prevent your computer from booting properly. Microsoft cannot guarantee that any problems resulting from the configuring of BIOS/CMOS settings
can be solved. Modifications of the settings are at your own risk.

Hope this information is helpful. Please do let us know if you need further assistance, we’ll be glad to assist you.

Thanks.

 

bios

Hi all i am new in this forum, i need meanings step by step of each item listed in the bios Phoenix-Award

 

Overclock your hard drive!!!

Heres a much easier hack that I realized quite a few years ago that really does work!

REQUIREMENTS:

• Hard drive with molex power connection.
• PSU with more than 1 strand that has molex plugs on it.
• Wire strippers, soldering iron if you're fancy, electrical tape if you're not.

STEPS:

• Take the strand of connectors from your PSU, and decide which one will be the donator for this overclocking adventure.
• Cut the yellow and orange cables, then twist them together.
• Find the power connector you've chosen as the overclocking connector, and release the orange cable from the connector. Now use your preferred method to bind them together, then place it back together.
• Plug in a drive and feel the speed!

Congratulations! You've just overclocked your hard drive!