Windows 10: no dp signal from your device

Hi.When I turn on my PC, monitors wake up, but during the startup, this message apears "no dp signal from your device", and the monitors go to sleep.I make a hard shut down, and start again, and now it works fine.This happens every time for some weeks, perhaps after a update??Some idea to fix the problem? I have tried all cabels and connections, and found no fails.

:)

 

xbox 360 splitting video signal

Hello,

I just happened to come over your post.

Could you please tell us exactly where you don't get any signal? Both the screen and the computer (via capture device)?

Have you tried the following?

• Make sure you get a signal to the screen when using an HDMI cable directly from the Xbox 360 to the screen. Please make sure all cables work.
• Make sure you get a signal to the capture card with the same cables.

If you get a signal on the screen but not on the computer, could you please try the following?

• Set the Xbox 360 to output at 720p. The frame rate will (or should) be 59.94.
• If possible, make sure you capture the video with the same settings on the computer.
• Try any other settings if this does not work.

If it still does not work, please try this in the same order:

• Power off computer (and capture device) and Xbox 360.
• Power on computer (and capture device) and wait until the capture device is properly powered on and initialized.
• Power on the Xbox 360.
• Make sure you can capture properly.

If it still does not work, make sure that one or more of the following are not defective:

• The HDMI-VGA/composite adapter.
• The VGA cable.
• The capture device (could be just the input connector).

If that works, please install the HDMI splitter.

I am wondering a bit why you show us the wires inside the HDMI cable. Did you remove the isolation and/or do something with the wires?

I am not sure what else to suggest at the moment.

Could you please tell me/us the model of your capture device, and also the adapter between the HDMI cable and capture device?

Regards,
awd_

 

Hdmi to dp

I bought a hdmi to dp cable my monitor is hdmi but my pc has dp so i plug it in but it isnt working ( No Signal )

 

wi-fi signal is weak

Hey Jonian,

This issue could have occurred due to these reasons:

• Incorrect network settings.
• Network adapter is not working properly.

I suggest you to try the steps listed here and check if it fixes the issue or else contact your ISP for weak signal.



Method 1: I suggest you to refer the article and check if it helps to fix network connection issue.

Windows help & learning



Method 2: If the issue persists, I suggest you to refer the steps in the article which will help to fix common issues with network connection. Check if it helps.

Fix Wi-Fi connection issues in Windows - Microsoft Support



Hope this information helps.