Windows 10: "Out of range" Monitor

Today, after 6 months of using my second monitor LG 27MK60TM-B with my ASUS ZenBook UX330UA-AH55, the LG monitor now reads "out of range." I connected my computer to a different monitor, and the picture is awful, but it works. I tried reinstalling the graphics card drivers, following several suggestions from other threads, but no luck. Any ideas?

:)

 

Dual monitor issue - 2nd monitor "out of range"

Hi,



Thank you for writing to Microsoft Community forum.



The error message Out of Range usually occurs when the video card feeds the monitor, a signal stream in excess from what the monitor can handle.



I suggest you to try the steps listed below and see if it works for you:

• Boot the computer in
  Safe Mode, and right click on the Desktop.
  
• Select Display Properties and choose a lower resolution.
  
• Reboot the machine and check if it works.
  
• If the issue persists, boot the computer again in
  Safe Mode, and go to Display Properties.
  
• Click on Advanced Display Settings, and choose
  Display Adapter properties.
  
• Under Monitor tab, choose
  60 Hz as the Screen Refresh rate.
  
• Apply the changes, boot the PC in normal mode to see if it works.
  

Regards,

 

Monitor 1 out of Range Error

Hi Jill,

It is possible that the signal from your video adapter exceeds the scan range of your monitor. Also, It is possible that the refresh rate of your
PC is incompatible with your monitor. To further assist your concern, kindly answer these following questions:

• Is your monitor equipped with either G-Sync™ or FreeSync™ technology?
• Are you connecting your monitor to your GPU or to your motherboard?

We'll be looking forward for your reply.

Regards.

 

INPUT SIGNAL OUT OF RANGE while playing Wizard 101

Hi,

Thank you for writing to Microsoft Community forum.

• Since when are you facing this issue?
  

This happens if the signal from the video adapter exceeds the scan range of the monitor. The video card is feeding the monitor a signal stream in excess of what the monitor can accommodate. The two main causes for this are that either the resolution
or the vertical frequency is set high.

You may try the troubleshooting steps listed in HP and Compaq Flat Panel Monitors - Flat Panel Monitor Displays Message about
No Signal, Signal out of Range, Sleep, or Power Save and check if it helps.

Regards,