Windows 10: Partition Issue

I recently installed a new M.2 drive that ive installed the OS onto, what ive since noticed via minitool partition wizard is that there is 3 other partitions along with the C Drive, are they all needed or can i merge hem into 1 drive?

:)

 

W7 Hard drive partition issue

to get rid of that 100 meg windows partition that setup creates for you on a new install on a blank hdd:

- press shift+f10 when on the partition management screen in setup <-- this opens a command prompt
- diskpart <-- start the windows command line partition management tool
- list disk <--- list the installed hdds in this computer for the next step
- select disk 0 <- might have to replace 0 with the number of the correct disk
- clean <-- this will erase all data on the disk you selected one step up- dont use the wrong disk!
- create partition primary <- creates a primary partition taking up all space on the drive, adjust the command if necessary
- exit, exit to exit diskpart and the command prompt
- click refresh in partition manager and select your newly created partition and install to that

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

Clean Install Windows 10 partition issue

Hello,

Thank you for writing to Microsoft Community Forums.

I appreciate the troubleshooting steps performed to resolve the issue. However, let’s try with the further troubleshooting steps and see if it works. Initially, I would suggest you to create a bootable media with a USB/Flash drive of capacity 8GB.
For better understanding, you may watch the video with the procedure from the article on
How to Clean Install Windows 10 on a PC Step-by-Step
Guide.

Set the boot priority to USB once after creating a bootable media using a USB and proceed with the Windows Installation. On the drive selection window, press Shift + F10 keys to open the Command Prompt. Then follow the steps listed
below:

• Type the following command in the Command Prompt window and press Enter:
  diskpart
  
• Once after executing the above command, type the following command to list the current drives and press Enter:
  list disk
  
• List disk will give you the list of drives, use the following command to select the drive and press Enter: select disk 0
  
• Type the following command to check if the disk is online: online disk
  (if the disk is not online)
  
• Type the following command to clean the drive and press Enter:
  clean
  
• To create a partition, type the following command and press Enter:
  create partition primary
  
• To select the partition that you created, type the following command and press Enter:
  select partition 1
  
• To set the partition active, type the following command and press Enter:
  active (if this is the boot partition)
  
• Type the following command to assign a drive letter and press Enter:
  assign letter(letter)
  

• After completing all this, close the command prompt screen and click on
  refresh button.
  
• Then you will only have one drive with “unallocated space”, just select the partition to start the installation.
  

Let us know how it goes and I look forward to hearing from you soon.

Regards,

Mala S

Microsoft Community - Moderator