Windows 10: PC can not be reset since this one!?

I unscrewed my PC yesterday because I replaced my new SSD with my old HDD. Then I wanted to boot my PC everything worked fine then I used this partition drive program to detect my SSD then I wanted to reset my PC (had another SSD inside with Windows on it) and then my SSD (the old one) was not detected I couldn't reset it, it just wanted to reset my new SSD problem there was nothing on it yet I can access my SSD (the old one) but I can't reset it what is the reason.

:)

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

can i reset my pc from the os after downloadind windows 10 from the website

Hi,

Welcome to Microsoft Community.



I understand your inconvenience. We will assist you to resolve this issue.



Yes, you can reset the pc from windows 10 after updating I suggest you to refer the steps given below.

• 
  To go start.
  
• 
  Go to Settings.
  
• 
  Click on Update & security.
  
• 
  Click on Reset this PC.
  
  
  

I suggest you to refer the below link and follow the steps for reset pc and refer the options.

http://windows.microsoft.com/en-us/windows-10/windows-10-recovery-options



Hope this information is helpful. For any further assistance on Windows, feel free to post your query on Microsoft Community Forum.

Thank you.