Windows 10: PC doesnt boot after sleep mode

Hi! When I turn my pc into sleep mode and want to turn it on, it doesnt boot. The lights are on and the fans are spinning, but I dont get a picture on my monitor. Only when I restart my pc with a button on my pc case, it boots afterwards. Please help me

:)

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.

 

Sleep mode

Hi Adam,

For us to better assist with your issue on sleep mode, we'd like to ask a few questions.

• Have you made any updates to your computer before experiencing this issue?
• What troubleshooting steps have you done so far?

In the meantime, we suggest that you refer to this thread and follow the answer of Andre
Da Costa to troubleshoot the issue with sleep mode missing.

You can also refer to this article that was
created by Andre Da Costa to enable sleep mode.

Looking forward to you response.

 

Trouble Putting PC to Sleep  

I finally determined what the cause of my PC waking up right after I invoke sleep function Start > Power > Sleep. I recently purchased a Velocifire wireless (2.4ghz) keyboard that also comes with a USB cord so it can be used in corded mode. When used in corded mode, sleeping the PC is not a problem. When I use the wireless dongle, the PC refuses to sleep for more than a second. So, the wireless mode of this keyboard is what triggers the problem. In addition to the things I've tried in my original post, here are the results of some suggestions you guys made:

• Created a new fake user and logged in under than user. Same behavior.
• Started PC in Safe Mode. Unfortunately, in Safe Mode sleep functions are limited to the monitor and hard drives. Nothing to put the PC to sleep.
• Tried going into sleep via Alt + F4. Same behavior.
• powercfg -a reports S3 is active on my system.

There are no obvious irregularities in Device Manager. The dongle shows up under USB Serial Bus Controllers as a USB Composite Device.

• General Tab says "This device is working properly".
• In Driver Tab, I tried searching for a better driver, but Windows says there is no better driver.
• There is no Power Management tab.

So as it turns out, all of things I've tried appear to have been a waste of time as it was not addressing the wireless function of the keyboard. I contacted the manufacturer and they suggested that I delete the USB Composite Device entry, re-boot and re-insert the dongle. However, that did not change inability to sleep the PC. Any other ideas?