Windows 10: pc is starting but no signal booting is not working

hello as of late i wanne to reset my PC because there where a lot of things i didnt know. so i was scared zo i looded it op my asus x299 but i think i removed the storage by accident. now i am trying everthing but nothings helps i have a 64 windows 10 disk but not reader. also something i find wierd is some light going on other wont after many tries everthing did go on terms of lights en vents but still no signal. i dont know what to do do i need to by a new CPU or motherboard and where do i find my ssd samsung card..

:)

 

PC boots up but monitor shows 'no signal' and keyboard not working.

Thanks for your answer, however i have checked all cables and connections and these are fine (work with other pc). Re step 2 - i cannot boot to safe mode as there is no monitor signal so i cannot see anything except a black screen.

how can i boot my PC to safe mode if i cannot see anything?

I can't change the signal resolution either as no monitor!!

 

PC boots up but monitor shows 'no signal' and keyboard not working.

My W10 PC boots up, fan spins, HDD spins but there is no output to monitor, which shows 'no signal' and the keyboard does not light up. I have tried all the suggested diagnostics such as unplug power, take out the CMOS battery, re-seat the RAM, clean RAM etc but nothing. It did come back on a few weeks ago for a few days then reverted to display showing 'no signal'. Any suggestions how to get this PC to display and work again are welcome.

Many posts i have read suggest entering BIOS etc or settings - i cannot do this as no display!

Please suggest fixes for my situation as above.

Thanks

 

HDMI no signal only during Boot

Hey Guys,

I've just built myself a new computer, all working well, however on boot my HDMI monitor receives no signal until Windows has fully loaded. It would receive signal to see the Bios screen pop up then go blank with no signal and then about 5 seconds later will receive signal and display the desktop.

I've now added a second monitor connected via DVI, even though this is not set as my primary monitor the bios screen displays on it and I can see the entire boot process through this monitor, it will then load to desktop of which a split second later my primary HDMI monitor will then receive signal and start to display.

It's not a massive issue but it's quite annoying, any suggestions?

I'm using a GTX 970 and Windows 8.1 Pro 64-bit.

Cheers,